Common questions

Why does my Chevy heater blower fan not work?

Why does my Chevy heater blower fan not work?

Re: Heater blower motor fan won’t work in 2003 Chevy… You have a fan resistence it should work in high speed only or not at all check all fuses to be sure you should have a 30 amp for the motor and is the motor new or used try the motor at the battery first to see if working before going further

What are common reasons my Chevrolet Suburban has heater problems?

What are common reasons my Chevrolet Suburban has heater problems? While there are a variety of reasons your Chevrolet Suburban heater is not working, the most common 3 are a broken heater blower motor, a problem with the thermostat, or a failed heater blower motor resistor.

Why is my blower not working on my GMC Sierra?

When you switch to high,the blower motor relay coil circuit is grounded and voltage is now applied directly through the relay to the blower motor; bypassing the resistors. So, I would look to see if the relay is ok. It is a five terminal relay.

Why is my blower not working on speed 5?

If your blower is not working on speed 5 then the blow motor resistor (I think its called that) is burnt and you need a new one. It is a 5 minute fix.

Why is my blower motor only working at high speed?

The first thing that needs to be determined is the type of noise that is present and the possible sources. Rattling or knocking noises while… The blower motor only working on high speed is a common symptom of a failing blower motor resistor; but the fact the radio stopped working at the same time is unusual.

How is a blower fan connected to a battery?

A blower fan is connected to the negative battery terminal (also called ground) on one end and to the positive battery terminal through a blower motor resistor on the other end. The blower resistor is connected in series to the blower fan motor.

What to do if your Chevy Silverado blower does not work?

Although you can jump to just separating the steering column cover. I find it much easier to remove the instrument cluster trim panel first. Then the knee bolster or under dash cover. Next a well placed screw driver and a little twisting and the tilt lever pops out.

Why is my heater fan not working on my 2003 Chevy?

Heater blower motor fan won’t work in 2003 Chevy pickup half ton. Replaced motor had power on both wires in motor plug. I grounded the black one out now no power on either one.

How can I Make my Chevy heater blower fan work?

You have a fan resistence it should work in high speed only or not at all check all fuses to be sure you should have a 30 amp for the motor and is the motor new or used try the motor at the battery first to see if working before going further You can’t post conmments that contain an email address.

Where is the heater fan blower motor relay located?

Automotive Mechanic 25 years of experience Hello – the blower fan relay is located behind the glove box – small black plastic square. Make sure both fuses for the HVAC/heater are good, and have power to them (one is 10 amp, one is 30 amp).

What to do if your AC or heater is not blowing?

If your Blower Motor for the AC or Heater suddenly stopped blowing, look here first, it might save you several dollars. Situation, we have a friend that owns a 2017 Chevy Trax LT, she is a nurse who works with my wife, single mom and on a single mom budget.

What happens if you have a bad blower motor?

The blower motor is the component responsible for pushing air through the vents of your vehicle’s heating and air conditioning systems. Without it, the AC system will not be able to circulate any heated or cooled air.

What causes a bad or failing blower motor relay?

Blown fuses. One of the first symptoms of a bad or failing AC blower motor relay is a blown AC blower motor relay circuit fuse. If the blower motor relay develops any sort of problem that hinders its ability to properly limit and distribute power, it may cause the blower motor fuse to blow. Any sort of electrical spikes or excessive current…

What causes a fuse to blow on a blower motor?

If the blower motor relay develops any sort of problem that hinders its ability to properly limit and distribute power, it may cause the blower motor fuse to blow. Any sort of electrical spikes or excessive current from a bad relay will blow the fuse and cut power in order to protect the system.

What can cause heater not work?

The most obvious reason an electric heater doesn’t work is that it’s not receiving any power . Start by checking the circuit breaker to see if it has been tripped. If it has, it’s an easy fix – simply turn it off and turn it back on again. You may also have to replace the fuse if it has blown.

Why is my AC heater not working?

The potential issues here vary whether your heating has gone out or your car’s AC system is on the fritz. Common reasons for the heating system not to work include the following: Low coolant. Air in the coolant system. Malfunctioning heater core. Failed (or failing) thermostat.

Why is my furnace blower motor not working?

Another common problem with furnace blower motors not working is caused by the “three D’s”; dust, dirt and debris. These three alone can cause overheating of the motor, which in turn causes the windings and bearings to burn up quicker. Dirt, dust and debris can cause the blower motor to overheat and seize up.

Why would a car heater stop working?

Here are a few of the more common reasons that’s causing the car heater to not work properly: The amount of coolant in the system is too low. When your vehicle’s engine has cooled down, open the radiator cap and check the level of coolant.

Is the blower motor on a Chevy Silverado working?

Blower Motor does not work on 1 and 2 speed chevy silverado – YouTube I had a Bad Relay. I got one here https://amzn.to/2PSr6fQ It seems the 88-94Trucks have a different system to control the speeds than the 96-00 OBS style Ch…

How does a high speed blower motor work?

In the highest fan speed state, the blower resistor is bypassed completely and the fan is effectively connected directly to the car’s battery, allowing maximum current to be supplied to the blower motor.

Re: Heater blower motor fan won’t work in 2003 Chevy… You have a fan resistence it should work in high speed only or not at all check all fuses to be sure you should have a 30 amp for the motor and is the motor new or used try the motor at the battery first to see if working before going further

Why is my blower not working in Hi ( 5 )?

The usual failure of the resistor pack is if it works in HI (5) but not in any other mode or just a few modes. When you switch to high,the blower motor relay coil circuit is grounded and voltage is now applied directly through the relay to the blower motor; bypassing the resistors. So, I would look to see if the relay is ok.

When you switch to high,the blower motor relay coil circuit is grounded and voltage is now applied directly through the relay to the blower motor; bypassing the resistors. So, I would look to see if the relay is ok. It is a five terminal relay.

The first thing that needs to be determined is the type of noise that is present and the possible sources. Rattling or knocking noises while… The blower motor only working on high speed is a common symptom of a failing blower motor resistor; but the fact the radio stopped working at the same time is unusual.

What to do if your Silverado blower won’t work?

Head under the hood and check the blower motor wiring to make sure it is getting power to it. If it is, then your only option is to remove the blower motor and have it tested or replaced. You can do so yourself if you have the equipment, or have it done at the dealership or parts store. Figure 3. Silverado blower motor and fan assembly.

Why does my AC fan only work on high?

If your speed selector for your AC or Heat only works on high, or low, or if its missing any particular speed, this video will show you how to fix it once and for all. This is a fix for 2nd generation Dodge Rams (1994-2001-2002 2500/3500) Loading…

Can a Silverado dual temperature switch be replaced?

You can check behind the dash and inspect that the contact points of the switch aren’t dirty, damaged, or shot. If they are, you can replace them and try the system again. You can also inspect the wiring to make sure it is in good condition. Figure 2. Silverado dual temperature switch selector.

Why is my blower not working on my Chevy Silverado?

Another common problem will be the blower motor will stick in the ON position and never shut off. You can access the resistor module behind the fuse box located on the driver’s side lower dash compartment. You must visually inspect the resistor, and make sure it isn’t melted or burnt. If it is, then replace it.

What causes a blower fan to not work?

When this happens, you may notice that you will not feel anything blowing out of the vents at all. This may also cause the blower motor to work intermittently. A blower fan is connected to the negative battery terminal (also called ground) on one end and to the positive battery terminal through a blower motor resistor on the other end.

A blower fan is connected to the negative battery terminal (also called ground) on one end and to the positive battery terminal through a blower motor resistor on the other end. The blower resistor is connected in series to the blower fan motor.

You can check behind the dash and inspect that the contact points of the switch aren’t dirty, damaged, or shot. If they are, you can replace them and try the system again. You can also inspect the wiring to make sure it is in good condition. Figure 2. Silverado dual temperature switch selector.

Author Image
Ruth Doyle