Where is the recirculation air door actuator located?
Where is the recirculation air door actuator located?
The recirculation door actuator (1) is a reversible, 12 volt direct current (DC) servo motor, which is connected directly to the pivot shaft lever of the recirculation-air door. The recirculation door actuator is located on the right side of the HVAC air inlet housing.
What kind of actuators are on a Dodge Avenger?
By checking RockAuto.com they list the same OEM part number and Dorman part number for the 2009 and 2010 Dodge Avengers. I bought two Mopar actuators on Ebay for a decent price and replaced the actuators on the re-circulation door and heat/cold blend..
How does the a / C heater door actuator work?
The A/C-heater control learns the recirculation-air door stop positions during the calibration procedure and will store a diagnostic trouble code (DTC) for any problems it detects in the recirculation door actuator circuits. The recirculation door actuator cannot be adjusted or repaired and it must be replaced if inoperative or damaged.
Where is the blend door actuator on my car?
The blend door is under the dash. You will have to disconnect the negative side of the battery before you start. Then remove any silencers or covers. The dash will not have to be removed. The blend door actuator is located on the left side of the HVAC unit under the dash.
The recirculation door actuator (1) is a reversible, 12 volt direct current (DC) servo motor, which is connected directly to the pivot shaft lever of the recirculation-air door. The recirculation door actuator is located on the right side of the HVAC air inlet housing.
By checking RockAuto.com they list the same OEM part number and Dorman part number for the 2009 and 2010 Dodge Avengers. I bought two Mopar actuators on Ebay for a decent price and replaced the actuators on the re-circulation door and heat/cold blend..
The A/C-heater control learns the recirculation-air door stop positions during the calibration procedure and will store a diagnostic trouble code (DTC) for any problems it detects in the recirculation door actuator circuits. The recirculation door actuator cannot be adjusted or repaired and it must be replaced if inoperative or damaged.
Why is my Blend door actuator not working?
You could walk by it and you’ll hear it clicking, BUT the moment you open the door any door it will quit. When you start the car it will go off for about 15 seconds then stop. I have noticed that the radio will sometimes be on upon returning to the vehicle after coming out of the store. I suspect the door jamb switch or a bad ground.
