Where is the car thermostat supposed to be?
Where is the car thermostat supposed to be?
Any liquid-cooled car engine has a small device called the thermostat that sits between the engine and the radiator. The thermostat in most cars is about 2 inches (5 cm) in diameter. Its job is to block the flow of coolant to the radiator until the engine has warmed up.
Do you need to change the thermostat on a Dodge Durango?
If your Dodge Durango has an overheating problem, you may need to replace the thermostat. For Durango owners, this process is a bit involved, but once you remove all you need to remove to get to the thermostat, you’ll need to decide if you want to stick with the factory-set 192-degree thermostat or install a lower-temperature one.
What happens if you put the thermostat in the wrong direction?
Not as stupid as putting it in the wrong way. Think of it this way: The thermostat tries to keep the engine temperature constant. So the sensing part of the thermostat has to be toward the engine. Coolant over the thermostat will cause it to close immediately. The temperature
Where is the radiator hose on a Dodge Durango?
Leave all wiring attached except for 4-wheel drive indicator lamp wiring at the rear of the generator. Follow the top radiator hose to the intake manifold if the engine of your Dodge Durango is 5.7 or 5.9 liter, and the bottom hose if the engine is 3.7 or 4.7 liter.
Why does the thermostat have to be near the engine?
Think of it this way: The thermostat tries to keep the engine temperature constant. So the sensing part of the thermostat has to be toward the engine. Coolant over the thermostat will cause it to close immediately. The temperature spring. Also, your thermostat may have a small hole with a “jiggle pin” the air out of the system.
If your Dodge Durango has an overheating problem, you may need to replace the thermostat. For Durango owners, this process is a bit involved, but once you remove all you need to remove to get to the thermostat, you’ll need to decide if you want to stick with the factory-set 192-degree thermostat or install a lower-temperature one.
Where is the radiator draincock on a Durango?
Disconnect negative battery cable from the battery. Use a jack and jack stands or wheel ramps to raise the front of your Durango. Locate radiator draincock at left side of the bottom of the radiator, facing the rear of the Durango. Drain coolant into a suitable container. Allow reserve tank to empty, then remove radiator cap and continue draining.
Can a thermostat be installed in the wrong direction?
Answer: A thermostat installed backward will cause the engine to overheat quickly, similar to a thermostat being “stuck closed.” Therefore, always double check that the thermostat is installed in the correct direction, and if equipped with a jiggle valve you install it according to the Factory Service Manual.
Which is the deep end of the thermostat?
Therefore, the deep end (Arrow C) of the thermostat always gets installed going towards, or into, the engine. (Arrow A) in the photo is the new thermostat gasket on the new thermostat, make sure to always use a new thermostat gasket if your Factory Service Manual calls for one.
