What kind of engine does a 93 S10 have?
What kind of engine does a 93 S10 have?
I have a 93 S10 4.3 Automatic 2wd, I was driving and it just died, before that the engine idled high then low then smoothed out. Could not hear fuel pump kicking on and had it towed home. Next day put a fuel pump in it and a fuel pump relay, cranked it up before I put bed back on it ran and idled fine.
Is the fuel pump on my 93 S10 working?
Yes got a 93 S10 I was driving down the street it stopped working I put a new fuel pump in it and you feel filter and still no start is there anybody out there that can help me 13 people found this helpful.
Is there a problem with my Chevy S10 pickup?
>10v at A, <10v at D (This is the problem) The ICM is new also. I have also replaced the Coil Wire, Cap & Rotor. The Crankshaft Postion Sensor tests fine. (Alternating 5v pulses) There is also >10v going to the coil at its terminal A. The grounds are good at the coil and ICM.
What kind of engine does a 1994 S-10 have?
1994 S-10 4×4 pickup, 4.3L, VIN W. 215,000 on the truck, 40 or so on a GM crate engine. A week or 2 ago the truck started missing and surging anywhere but idle or wot.
How often does a 94 S-10 4.3 drop rpm?
After you take it out and drive it, it’ll idle fine for a couple minutes, then will drop a couple hundred rpms every 30 seconds or so for just a count, then back to normal. Any ideas? I’m pulling my hair out.
Can You bench test a 94 S-10 4.3?
The good news is that they are testable. You can carefully remove it from the bottom of the distributor by removing the two screws and unplugging the wire clips, and have it bench tested at some of the better Auto Parts stores. Be very careful as the wire clips are brittle and will easily break.
When was the second generation Chevy S-10 made?
In this article, we consider the second-generation Chevrolet S-10, produced from 1994 to 2004.
Why does my Chevy S10 Pickup not start?
It still will not start. The first time I tested ICM terminal D, it gave a reading of >10v. Since the replacement of the PCM, it shows <1v at terminal D. This is still a No Spark condition. Last summer I replaced the fuel pump & filter, the spider fuel injection assembly, and the heads.
What kind of engine does a 1988 Chevy S10 have?
I have a 1988 S-10 with a 2.8L V-6 Carb body fuel injection. The vehicle starts every time and will run from a few seconds to sometimes up to 15-20 minutes. Then it just dies like you turned the key off.
Can a 1995 TBI be fitted with a 4.3 L engine?
In other words, a 4.3 L Engine from a 1995 will bolt in perfectly into blazers of earlier years that also were equipt with a 4.3 L engine. From what I understand the only difference may be the intake manifold, as the TBI and CPI use different types of manifolds.
Is the 95 Blazer compatible with the S-10?
So the 95 Blazer is fitted with a crank sensor hole in the timing cover, where as the earlier models were not, and the timing cover on the 95 does NOT match up to the block on earlier models. So you all had it right, I would not be able to do this swap without changing the wiring harness. So I have now dropped that ideal.
What to do if your Chevy S10 won’t start?
EASY…Popping, Vapor locking…Jump time??… 1995-2008 – YouTube If playback doesn’t begin shortly, try restarting your device. Videos you watch may be added to the TV’s watch history and influence TV recommendations. To avoid this, cancel and sign in to YouTube on your computer.
Why does my GM 4.3L engine not start?
No Start Condition Basics There are three very basic components that the engine, in your GM vehicle, needs to start and they are: Air, Fuel and Spark. When your 4.3L, 5.0L or 5.7L GM vehicle cranks but does not start, it’s because one of these components is missing from the mix.
Is the crankshaft postion sensor good on a Chevy S10?
The Crankshaft Postion Sensor tests fine. (Alternating 5v pulses) There is also >10v going to the coil at its terminal A. The grounds are good at the coil and ICM. There is good continuity at the white wire w/black stripe between coil and ICM.
How is my 1994 S-10 4.3 running?
Starts fine, even today when it was -15, fuel pressure 52 running, holds after shut down, newer plugs/wires/cap rotor, tested MAP sensor and tests good, tested resistance changes in TPS (with sensor out) and changes were smooth along range, unplugged every sensor I could find individually looking for changes, no luck.
I have a 93 S10 4.3 Automatic 2wd, I was driving and it just died, before that the engine idled high then low then smoothed out. Could not hear fuel pump kicking on and had it towed home. Next day put a fuel pump in it and a fuel pump relay, cranked it up before I put bed back on it ran and idled fine.
Yes got a 93 S10 I was driving down the street it stopped working I put a new fuel pump in it and you feel filter and still no start is there anybody out there that can help me 13 people found this helpful.
What was cause of 1998 Chevy S10 no spark?
9 people found this helpful. Again my 1998 Chevy S10 No fire was caused by what is called an ignition igniter which sit on the side of my coil bracket next to the coil. I hope this will help someone with the same problem.
What kind of engine does a Chevy S-10 have?
Chevy S-10 2.8L: The Chevy S-10 4.3 Liter Vortec engine largely replaced this first generation engine package, General Motors eventually ceased using this product in Chevy S-10 pickup trucks. 14. Chevy S-10 4.3L: This special engine for the 2-wheel version of the GMC Sonoma achieved up to 195 horsepower.
When did the Chevy’s 10 pickup truck come out?
It became the first genuinely compact pickup ever built on U.S. soil by a leading automaker. The S-10 underwent extensive permutations during its development. This pickup inspired versions of the Colorado in some overseas markets today. Chevrolet began producing the Chevy S-10 in 1981. It marketed the truck for the first time as a 1982 model.
How many liters does a 1997 Chevy S10 have?
In 1997, Chevy S10 vehicles had different hardware, so the hardware options built for gasoline components distributed less fluid. As a result, a typical product for a 1997 Chevrolet truck will have 2.2-liter hardware. Because the liters are reduced, some products for a 1997 Chevy pickup may be built with four cylinders.
Can a 1996 Blazer be used in a Chevy S10?
Hardware for GMC vehicles manufactured in 2003 with 4.3-liter components can be used with an S10, and 1996 Blazer items are suitable for a Chevy S10 as well. The 2003 Sonoma also has hardware that fits the S10 pickup.
Can a GM 4.3L Vortec engine be tested?
This isn’t possible on the GM 4.3L, 5.0L, and 5.7L Vortec engines with a ‘Spider’ fuel injector (the fuel injector is inside the intake manifold plenum and its outside electrical connector doesn’t allow for such a test).
What kind of fuel injection does a GM Vortec have?
I n 1992, General Motorsintroduced a very unique fuel injection system on its 4.3-liter Vortec V6 truck engine. Dubbed Central Port Injection, or CPI, the system looked and functioned much differently than previous designs. The CPI system utilizes one main injector that pressurizes six plastic tubes housed in the in- take manifold.
Why does my 1994 Chevy S-10 not start?
1994 Chevrolet S-10 4.3 tbi. I never get the signal to turn on the fuel pump or fire the injectors but if i poor gas in the intake once the truck starts it runs fine. Any ideas ? I have replaced the fuel pump relay oil pressure switch and computer.
What should the fuel pressure be on a 4.3L Vortec?
The fuel system in your 4.3L, 5.0L, or 5.7L Vortec engine needs at least 50 PSI of fuel pressure to start. The fuel pump produces much more than just 50 PSI of course.. but the bare minimum the engine needs to start is 50 PSI…
Why did my 1998 Chevy S10 not catch fire?
Again my 1998 Chevy S10 No fire was caused by what is called an ignition igniter which sit on the side of my coil bracket next to the coil. I hope this will help someone with the same problem. 10 people found this helpful.
Do you need a spark plug for a Chevy S10?
NOTE When performing the following tests, the vehicle’s battery must be fully charged. WARNING Never crank the engine or turn the ignition switch on with a high-tension spark plug wire or ignition coil wire disconnected.
Are there any problems with the Chevy 4.3 Vortec engine?
The 4.3 Vortec engines made from 1996-2002 (L35 and LF6) have been reported to have engine knock problems. In a properly functioning engine, fuel burns in even pockets instead of all at once. The pockets burn in even timing, in sync with engine cycles. Engine knock occurs when the fuel burns unevenly and out of sync with the engine cycles.
Again my 1998 Chevy S10 No fire was caused by what is called an ignition igniter which sit on the side of my coil bracket next to the coil. I hope this will help someone with the same problem. 10 people found this helpful.
The 4.3 Vortec engines made from 1996-2002 (L35 and LF6) have been reported to have engine knock problems. In a properly functioning engine, fuel burns in even pockets instead of all at once. The pockets burn in even timing, in sync with engine cycles. Engine knock occurs when the fuel burns unevenly and out of sync with the engine cycles.
NOTE When performing the following tests, the vehicle’s battery must be fully charged. WARNING Never crank the engine or turn the ignition switch on with a high-tension spark plug wire or ignition coil wire disconnected.
>10v at A, <10v at D (This is the problem) The ICM is new also. I have also replaced the Coil Wire, Cap & Rotor. The Crankshaft Postion Sensor tests fine. (Alternating 5v pulses) There is also >10v going to the coil at its terminal A. The grounds are good at the coil and ICM.
Where does the oil leak come from on a 1994 Chevy S10?
I have a 1994 s-10 2.2 L, manual trans, 2 wheel drive, AC, 184K. I have an oil leak and am having a difficult time determining the cause. Generally doesn’t use much oil. Seems to only leak when driving (under pressure). It appears as if it is coming from the right side of the engine slightly behind and below the oil filter.
What’s the problem with my Chevy S10 4.3?
I have this same problem with my 99 s10 4.3. the code reader says miss fire cylinder #2… so I replaced wires, plugs, distributer cap and rotor. after 2 days this problem got worse. again I read the codes and it read the same code, cylinder #2. good old GM I guess 71 people found this helpful.
What’s the no spark condition on my Chevy S10?
The first time I tested ICM terminal D, it gave a reading of >10v. Since the replacement of the PCM, it shows <1v at terminal D. This is still a No Spark condition. Last summer I replaced the fuel pump & filter, the spider fuel injection assembly, and the heads.
What do you need to know about the VIN on a Chevrolet?
This is the Chevrolet VIN decoder. Every Chevrolet car has a unique identifier code called a VIN. This number contains vital information about the car, such as its manufacturer, year of production, the plant it was produced in, type of engine, model and more.
How to find the VIN number of a Chevy S10?
It is possible to get market price of new or used Chevrolet S10 by VIN number. Every buyer must check Chevrolet S10 car history before getting a car loan or credit. Buying a used car?
What do you need to know about the Chevrolet S10?
Find all the latest facts, figures and Chevrolet S10 specs based on year, make and model. Chevrolet vehicle history report may contain the following information: title problems, prior damages, unsafe salvage rebuilds, odometer mileage, theft, past sales. What is VDS? VDS is a Vehicle Descriptor Section.
What does the VIN number on a Chevrolet car mean?
Every Chevrolet car has a unique identifier code called a VIN. This number contains vital information about the car, such as its manufacturer, year of production, the plant it was produced in, type of engine, model and more.
It still will not start. The first time I tested ICM terminal D, it gave a reading of >10v. Since the replacement of the PCM, it shows <1v at terminal D. This is still a No Spark condition. Last summer I replaced the fuel pump & filter, the spider fuel injection assembly, and the heads.
How much does a Chevy S-10 throttle body cost?
Rebuilt presre. reg on throt. bdy & replaced plugs,wrs.cap,rotor,ect. then it started poppin’ & pingin’. cometo find out coil was bad too. But I bought the truck for $400.00 & put about $65.00 into it, with oil change,& $25.00 worth of gas.Runs & drives like a champ now. Thanx again for your input. 10 people found this helpful.
9 people found this helpful. Again my 1998 Chevy S10 No fire was caused by what is called an ignition igniter which sit on the side of my coil bracket next to the coil. I hope this will help someone with the same problem.