What kind of belt system did Ford Bronco have?
What kind of belt system did Ford Bronco have?
Example of the Explorer 5.0 serpentine belt system installed in an early Bronco. Note that all the accessories are mounted high, instead of being buried in the dark reaches of the engine bay. This particular example is on a 5.0 Ford Racing crate motor.
What’s the difference between Mustang 5.0 and Bronco serpentine?
The Mustang 5.0 serpentine arrangement, on the other hand, puts the fan closer to the radiator than the stock Bronco configuration. During off-roading when the engine and frame flex relative to the body, the fan can (and will!) come into contact with the radiator if the clearance between the two is too small.
Is there a serpentine accessory drive belt conversion?
Although the discussion below appears long and involved, the conversion is actually fairly simple.
What to do with an Explorer 5.0 serpentine belt?
Access holes in the inner fender, filled with rubber plugs would be nice so you can remove it later if need be.) Finally, all six of the authors have contributed solutions for a wide range of the installation questions that come up for stock 302, 5.0, and 351, using various radiators and other commonly differing components used in early Broncos.
What kind of drive did a Ford Bronco have?
The rear axle was a Ford 9-inch axle, with Hotchkiss drive and leaf springs; the front axle was a Dana 30, replaced by a Dana 44 in 1971.
Can a 4.0 liter engine be swapped into a Bronco?
How to Swap a 4.0 Liter into a Bronco II. Step 1. Take lots of pictures of your Bronco II engine compartment and of a Ford Explorer’s engine compartment before you begin. Step 2. Gather all the parts and tools needed for the swap.
What kind of Dash do I need for a 1988 Bronco II?
If you’re swapping a 4.0L in to a 1988 or older Bronco II you’ll need the dash from the donor vehicle. If you’re swapping a 4.0L in to a 1989 or 1990 Bronco II you can use your existing dash.
How to check the authenticity of a Ford Bronco?
This format was implemented by the ISO institute. Every car manufacturer is obliged to mark all its vehicles in this special format. This online service allows a user to check the validity of the car and get detailed information on almost any VIN number, search for Ford BRONCO car parts and check the car’s history.
What was the problem with the 1986 Ford Bronco?
For the 1986 model, the problem was traced to the nylon fuel lines that were installed on the fuel-return side of the fuel-pressure regulator-they we found to be especially prone to cracking.
Are there any changes to the Ford Bronco II?
Although the front fascia of the Bronco II experienced a major redesign, there were little changes elsewhere for the compact SUV as it approached its final years.
