Common questions

How do you set the ignition timing on a 351M?

How do you set the ignition timing on a 351M?

The ignition timing for the 351M engine was 8 degrees before top dead center (BTDC). To adjust the timing, the engine should be set at an idle speed of 800 rpm and all accessories should be turned off. The distributor vacuum hose should be disconnected and plugged.

What was the ignition timing for the 1978 M Block Bronco?

1978 M-Block Ignition Timing Specifications Model Application Initial Timing Bronco 351M, auto trans 14° BTDC Bronco

What is the initial timing of a Bronco?

Initial Timing Bronco 351M, auto trans 14° BTDC Bronco 351M, auto trans, CA emissions 8° BTDC Bronco 351M, manual trans, CA and 49-state 6° BTDC

How do you time a Ford 351 engine?

Use a wrench to loosen the distributor hold-down bolt. Loosen it just enough so that you can turn the distributor with some effort; otherwise, it will move by itself when you start the engine. Start the engine and shine the timing light down onto the timing pointer and balancer. Be careful of moving belts and the fan.

When was the Ford 351 used in the Bronco?

It was used in the Ford F-150, 250, 350 and the Ford Bronco from 1977 to 1979. You can purchase a rebuilt Ford 351 on the aftermarket. Any installation or modification of the engine should be done by a professional. The pistons had a firing order of pistons 1, 5, 4, 2, 6, 3, 7, 8.

Use a wrench to loosen the distributor hold-down bolt. Loosen it just enough so that you can turn the distributor with some effort; otherwise, it will move by itself when you start the engine. Start the engine and shine the timing light down onto the timing pointer and balancer. Be careful of moving belts and the fan.

It was used in the Ford F-150, 250, 350 and the Ford Bronco from 1977 to 1979. You can purchase a rebuilt Ford 351 on the aftermarket. Any installation or modification of the engine should be done by a professional. The pistons had a firing order of pistons 1, 5, 4, 2, 6, 3, 7, 8.

What is the firing order of a 351M engine?

The pistons had a firing order of pistons 1, 5, 4, 2, 6, 3, 7, 8. The ignition timing for the 351M engine was 8 degrees before top dead center (BTDC). To adjust the timing, the engine should be set at an idle speed of 800 rpm and all accessories should be turned off. The distributor vacuum hose should be disconnected and plugged.

When did Ford stop making the Ford 351?

The 351 was produced from 1969 until 2001, but complete engines can still be purchased. Engine timing is accomplished in the same manner as any Ford V-8 engine. Locate the timing pointer attached to the timing chain cover, below the water pump on the passenger’s side of the engine.

Author Image
Ruth Doyle