How do you reset the check engine light on a 2012 Ford Focus?
How do you reset the check engine light on a 2012 Ford Focus?
First thing You will want to do is put Your key in the ignition and turn on ON. Now, insert the OBD II scanner into Your vehicle’s OBD II port. You will now follow the directions on the screen to reset the check engine light. Once done, turn the ignition to OFF.
Is there a fault in my Ford Focus?
I have recently bought a 2005 Ford Focus TDCi 1.8. In the first week it developed a fault with a loss of power and the ‘Engine System Fault’ warning light came on.
Can a Ford C Max have an electrical fault?
In my experience with a similar fault on a 1.8TDCi C-Max, Ford dealers have no idea when it comes to intermittent electrical faults. My car started hesitating, cutting out and displaying ‘Engine System Fault” just out of the warranty period.
Why did my Ford Focus go into limp mode?
The car went into ‘Limp Mode’ after displaying the ‘Engine System failure’ message on the dash after motorway drive. Called out the RAC but they could not diagnose any faults so recommended that the car was checked out by Ford. Ford diagnosed that the problem as a faulty throttle body and both this part and the wiring loom had to be replaced.
Is there a warranty on a Ford C Max?
In my experience with a similar fault on a 1.8TDCi C-Max, Ford dealers have no idea when it comes to intermittent electrical faults. My car started hesitating, cutting out and displaying ‘Engine System Fault” just out of the warranty period. The dealer diagnosed a crankcase sensor, which they replaced at a cost of £250.
How does the Ford Focus C Max work?
Once light and message show the power seems to die and lose acceleration up hill and stays like this until I turn engine off and on again. Acceleration on flat is fine (unless really put the foot down) and car is running great as normal, even drives at 80 on motorway including accelerating so long as I don’t accelerate going up hill.
I have recently bought a 2005 Ford Focus TDCi 1.8. In the first week it developed a fault with a loss of power and the ‘Engine System Fault’ warning light came on.
The car went into ‘Limp Mode’ after displaying the ‘Engine System failure’ message on the dash after motorway drive. Called out the RAC but they could not diagnose any faults so recommended that the car was checked out by Ford. Ford diagnosed that the problem as a faulty throttle body and both this part and the wiring loom had to be replaced.
How to tell if your focus has a transmission malfunction?
Ok, so to be clear My focus on transmission malfunction sign, revs more than suppose to, sometimes it reaches the 3 bar and normal I used to reach the 2 bar. when trying to stop the car (applying brakes ) it doesn’t realize that it needs to stop but you can feel the engine revs for 3 seconds.
