How do you change the clutch on a Kia Cee?
How do you change the clutch on a Kia Cee?
Disconnect the speed sensor and reverse light plugs and stow safely out of the way. Remove the locking pins holding the gear change cables in place ( pictured below) and carefully pop off the gear change cables and stow. Remove two bolts from the shift linkage bracket, enabling you to remove as a complete unit from the gearbox.
When to replace the clutch on a Kia Sportage professional?
Tickets for Mini UK Challenge with Morris Lubricants This month, after the customer reported that the clutch was worn out, Schaeffler REPXPERT Alistair Mason replaced the clutch on a 2013 Kia Sportage 1.7 CRDI diesel, which had covered 94,000 miles.
How do you change a clutch on a car?
Pull the transaxle away from the engine. Support the clutch with a clutch alignment tool. Slide the tool into the center of the clutch while you remove the pressure plate to transaxle bolts. Slide the clutch assembly off the transaxle. Clean the surface of the new clutch assembly and flywheel.
How do you remove an axle from a Kia?
Hold the steering knuckle and hub out of the way while you remove the axle from the Kia’s transaxle. Wedge the tip of a flat tip screwdriver between the axle and the transaxle housing. Pry the end of the axle out of the transaxle. Support the transaxle and the engine with a floor jack. You’ll need two floor jacks to accomplish this.
Disconnect the speed sensor and reverse light plugs and stow safely out of the way. Remove the locking pins holding the gear change cables in place ( pictured below) and carefully pop off the gear change cables and stow. Remove two bolts from the shift linkage bracket, enabling you to remove as a complete unit from the gearbox.
Pull the transaxle away from the engine. Support the clutch with a clutch alignment tool. Slide the tool into the center of the clutch while you remove the pressure plate to transaxle bolts. Slide the clutch assembly off the transaxle. Clean the surface of the new clutch assembly and flywheel.
Is there a way to remove the clutch start switch?
Please try again later. Clutch Master Cylinder Clutch Start Switch Removal and Replacement. The Clutch Start Switch prevents the engine from starting until the clutch pedal is pushed to the floor, a safety feature. On Ford, Mazda, Dodge, Ram, and Jeep applications R&R can be tricky until you see the technique.
Hold the steering knuckle and hub out of the way while you remove the axle from the Kia’s transaxle. Wedge the tip of a flat tip screwdriver between the axle and the transaxle housing. Pry the end of the axle out of the transaxle. Support the transaxle and the engine with a floor jack. You’ll need two floor jacks to accomplish this.
