Are there any Windows gauges or interior lights?

Us too any solution. 2008 f150 ford. Also bulb. Now no windows gauges etc… Fuses look good and replaced. 8 people found this helpful. More than likely cluster fuse is bad I had the same problem and the guy said in the post above yours it was F 21 cluster fuse and it says cluster keep a lab in the manual that is it

What to do if your interior light is not working?

Using your flathead screwdriver, gently pry off the plastic cover on your interior light, being very careful not to break it, then pull the light bulb out. Check the inside of the bulb to see if it’s blown, if the metal piece in it is not connected, then you need a new bulb.

What to do when your car gauges are not working?

The fuse should have power on both sides when the ignition key is turned to the on position. You can check this with an inexpensive test light or multimeter, or take your car to a mechanic if you don’t have the right tools or aren’t comfortable digging into a diagnostic like this.

What happens if you don’t adjust your light switch?

If adjusting the switch doesn’t work, you may have a blown fuse or bad lightbulb. Or, the entire switch may be faulty, in which case, have it replaced by a certified mechanic.

Why are the interior lights not working on my car?

If your interior lights used to stay on for a while after closing your doors, then there is probably some kind of timer module in the circuit. So if your fuses are good, the door jamb switch checks out okay, and everything else seems to be in working order, you may be dealing with a more complex problem.

What to do when your interior lights stop working?

With that in mind, a professional technician will be able to help you if you get this far without finding any obvious problems. When one or more interior lights stop working, and the others still work just fine, the problem is usually just a burned out bulb. This is very easy to check and fix.

What happens when your gas gauge is not working?

The gas gauge tells you how much fuel is in your gas tank and alerts you when it’s time to refuel. If your gas gauge is not working, the inaccurate information it provides may cause you to run out of gas unexpectedly.

If adjusting the switch doesn’t work, you may have a blown fuse or bad lightbulb. Or, the entire switch may be faulty, in which case, have it replaced by a certified mechanic.

Why are there no windows and no radio?

However, as a consequence, I’m left with no power to my windows, overhead interior lights, radio, and the dash gauges no longer work. The dash, still displays my air bag yellow symbol, because the wires are disconnected under the drivers seat, it blinks then stays on.

Why do my car gauges turn off and on?

Now the gauges turn off and on, is says damaged keys. Window wont come up, says pass door is open. Headlights flicker, turn signals dont work, inside lights come on and off, and now push start wont work. I can work on the mechanical but don’t know much on the electrical.

What should I do if my dash gauges are all out?

Dash gauges are all out and no power windows and no blower for air and heater and its as something shot or blew but the two places that I checked the fuses are not blown. What else might I do to see if the problem can be fixed without going into the shop? have the same problem? Will the vehicle start and run?

What kind of problem is a lost gauge?

First instinct would be a ground problem but from your description it sounds like a Class2 data line problem and not an easy fix without some advanced knowledge and a scantool.

Why are my gauges not working on my GMC Sierra?

Of course they couldn’t read it with a scanner when it wasn’t working, there was no communication on the Class2 data line. This isn’t something you’re going to fix poking and prodding, and you may even do more damage. The dealer is the best bet to diagnose this, it could by any of the dozen or so modules causing this problem or any of the wiring.

Is the Check Engine light on at night?

It displays blinkers and the night lights (green and red ambient lights to see the dashboard at night) come on at night, my break lights, blinkers, and head lights work fine. A.C. /heater blow fine. However, my check engine light no longer displays. I’ve check most of the fuses inside the truck, near the base of the passengers seat.

Why did my fuel gauge stop working on my explorer?

I hooked up a trailer that was wired incorrectly and it blew the trailer battery power fuse. At the same time, the fuel gauge seemed to st … read more Today, all the sudden, the fuel gauge, power windows and radio, all stopped working on my 2004 ford explorer. everything else seems to work fine.

What happens when your fuel gauge stops working?

All of a sudden my power windows, radio, and fuel gauge stopped working. I have checked all fuses and even replaced a sudden my power windows, radio, and fuel gauge stopped working..fuses… Vocational, Technical or Tra… 2004 Ford Escape with shift on column. Heard a pop. Smoke 2004 Ford Escape with shift on column. Heard a pop.

Why are my tach and Speedo radios quitting?

Other problems I have seen is a corroded connector on the ABS module, corroded wiring in the rocker sill harness, rodent damage, and even faulty radios. Why the tach and speedo would quit is a mystery, those are basically hard wired between the ECM and the cluster but anything is possible.

First instinct would be a ground problem but from your description it sounds like a Class2 data line problem and not an easy fix without some advanced knowledge and a scantool.

Why is there no radio in my Ford F-150?

Update?: I removed the plastic trim to expose the wiring harness on the carpet that moves along the side to the back and noticed there was quite a bit of water and the wires were all wet.

Why does my Ford radio keep cutting out?

Academy Ford 4 times, the first of which they told me nothing was wrong, the 2nd and 3rd time they replaced the radio, the most recent time they replaced the “Body control Module”. The issue is reoccurring and I’m getting to the end of my rope with this issue.

Why do I have trouble shooting my gauge cluster?

I have been trouble shooting my instrument cluster for months! My gauge cluster, windows, radio would all come and go as they pleased for any amount of time you can think of. Seconds, minutes or days. It would happen in every circumstance you can think of; key on engine off, engine running at idle, left turn, right turn, braking, or accelorating.

Why does the instrument cluster shut off intermittently while driving?

The batt light goes on and the entire instrument cluster (spedo fuel turbo temp etc ) shuts off .. when it’s off the climate control won’t work and the sun roof won’t work . Sometimes the abs light comes on before it shuts off. Turns on and off intermittently. I’ve checked fuses and cleaned battery connections and ground connections .. please help

Why is my power door lock not working?

Over last summer the battery went dead from sitting around for long periods of times. Thats when we found out the power door locks and drivers window wouldnt work. I found on this forum to disconnect the negative cable, and it solved the issue a few times.

Why is my BCM not working on my door lock?

If the RAP relay is not activating, the wipers will not work at the same time that the windows won’t operate. The BCM has little to do with the operation of the door locks. The only function that the BCM accomplishes regarding the door locks is unlocking/locking using the remote.

How can I tell if my airbag sensor is working?

To determine if the sensor is working okay, first check the “Passenger Airbag Off” indicator. If the seat is vacant, this light should be on. When the seat is occupied it should turn off implying that the airbag system is online and functioning. If the light is off when the seat is vacant or vice-versa, there could be a problem with the sensor.

What should I do if my airbag light is on?

Ensure that the passenger occupancy sensor is wired correctly. Check your airbag clock spring (especially if you have a faulty horn). Some airbag issues need professional hands to resolve. If you think your car is faulty and the above sensors seem to work fine, consult your mechanic/dealer.

Why does my airbag light flash on and off?

After continued use, the thin circuit bands that make up your airbag clock spring may become brittle or worn out. This leads to a sporadic connection of your driver’s airbag. If this is the case, the system will send a code to your computer and the airbag light will turn on or flash.

When does the airbag light come on in a car?

The airbag light, also known as the SRS light (supplemental restraint system), illuminates on the vehicle’s instrument panel usually only after the vehicle has been in an accident and the airbag has deployed.

How to reset an airbag light you it still runs?

Start the engine. The SRS light should come on for seven seconds, and then shut off and stay off. The airbag light has been reset. If you continue to drive your vehicle with the SRS light illuminated, you may risk an accidental deployment of the airbag. “How To Use Automotive Diagnostic Scanners (Motorbooks Workshop)”; Martin; 2008