Common questions

What is the hose that connects to the water pump?

What is the hose that connects to the water pump?

Radiator Hose
Radiator Hose. Most vehicle cooling systems are comprised of four main hoses. The upper radiator hose is connected to the thermostat housing and to the radiator. From the bottom of the radiator, is the lower radiator hose that is directed to the water pump.

Can you attach a hose to a hand pump?

The Baker hand pump spout to garden hose, thread adapter lets you attache a standard hose to your Baker Monitor hand pump stand. This will work on both the 11HD and 12HD hand pumps. It simply attaches to the spout opening.

How do you unblock a submersible well pump?

Pour a gallon of bleach down the well and pump intake to thoroughly clean the entire well structure. Flush out the system by draining the well using the submersible pump. It may take up to two days to flush out the chlorine, as you will also have to flush out the water appliances in the home.

Can a well pump become clogged?

It is not uncommon for submersible well pumps to become clogged with debris such as mud. A clog will interfere will the well pump’s ability to function properly. Fortunately, clearing the mud from the screen and the intake will restore the submersible well pump back to working order.

What to do if vacuum hose does not suction?

If you do not, you will unprime pump and add air to pump which then needs to reprime. Some older metal pumps will need water added to pump basket as they do not self prime. Newer style pumps which you normally can see in through top of pump lid will self prime and fill back up.

Why is my water pump not working properly?

Remove the debri and reposition the hose to start pumping again. The intake filter or screen can also be the culprit even without debri . While you must ensure the filter is fine enough to prevent damaging solids from entering the pump, too fine a filter for the water pump will restrict the flow right as the water enters the intake.

What should I do if my hand pump is not working?

Remove the fresh water supply hose from the hand pump to see if water is flowing from it. If water flow is not present you can try moving the hose end to a lower point in the boat or simply try sucking on it like a straw. If there’s good water flow, then your hand pump likely needs a rebuild.

Do you have to Prime vac.hose for skimmer?

You have to prime vac. hose by sucking on the end of it with your mouth until hose is filled with water, then attach vac. hose to skimmer. If you do not, you will unprime pump and add air to pump which then needs to reprime. Some older metal pumps will need water added to pump basket as they do not self prime.

Why is my water pump not working on my Boat?

Even pulled a hose off the exhaust riser and ran water from the hose through it until it filled the system and came out of the gimbel housing at the exhaust. Restarted with the muffs and water hose set at 60psi of water and still no flow through the pump.

What to do if your RV water pump is blocked?

Check to see that supply line from the fresh water holding tank to the RV water pump isn’t blocked for punctured. Sometimes there is a shutoff valve on this line. Make sure that it’s open. If the line is blocked with debris or ice, you’ll need to clear it somehow.

Why does my water pump have low suction?

Depending on the intake line you use, it is also possible that the line crimps, or is “sucked in” on itself. A few things to check. If possible use a rigid intake line. Sometime called a non-collapsible hose. Anything that impedes the water’s flow into the line will cause a reduction in the flow rate.

Why is my centrifugal water pump not working?

Be sure the filter is proper for the pump. Centrifugal water pumps are designed to operate with the impeller going in one direction. If it is going the opposite direction, the pump will not operate properly. This can happen if the electrical connections to the electric motor is not established correctly.

Author Image
Ruth Doyle