How do you remove the kick down Cable?
How do you remove the kick down Cable?
Remove the kickdown cable from the mounting bracket. This is accomplished by pressing in on the two tabs on either side of the housing, where it pushes through the bracket. Then you can slide the kickdown cable from the bracket.
How to install an o.e.accelerator cable?
You can use an O.E. Accelerator Cable Bracket or BPE part # 3395 Accelerator Cable Bracket on 4 bl. applications. (not included) Step 1. Remove O.E. accelerator cable retaining bracket and nut. Clamp O.E. accelerator cable retaining bracket in vise and file / grind approx 1/8″ off protruding tab. (see Figure 5A)
Where do I put the choke control cable?
Loosen the cable clamp screw on the bottom front side of the intake manifold for a forward pull choke, or on the air intake elbow for a reverse pull. 2. Place the choke control cable under the intake manifold from the front of engine (front pull choke). Insert the cable bowden wire into the choke control (front or reverse pull).
How do you remove the anchor pin from a gas pedal?
Using your needle nose plyers, you will need to remove the cotter pin holding a slotted anchor pin in the cable end. If your vehicle has a bolt holding on the cable end, then you would need to remove the bolt. Some vehicles may just have the cable fitting into a slot on the pedal.
How to remove kick down cable from car?
Remove all remaining kickdown linkage, rods, pivots, pivot studs, and throttle valve lever from vehicle. Throttle valve lever at transmission may be removed by loosening pinch bolt at rear of lever (upper lever on ’66 and later Torqueflites). Remove O.E. accelerator cable from carburetor. Locate Throttle Lever Adapter furnished in kit.
What kind of cable brackets do I Need?
Throttle Cable Bracket, Intake Manifold Mount, Billet Aluminum, Edelbrock, Performer, Performer AVS, Each Throttle Bracket with Return Springs, Adjustable, Carb Base Mount, Aluminum, Black, Edelbrock or 4150 Carb, Lokar, Kit
You can use an O.E. Accelerator Cable Bracket or BPE part # 3395 Accelerator Cable Bracket on 4 bl. applications. (not included) Step 1. Remove O.E. accelerator cable retaining bracket and nut. Clamp O.E. accelerator cable retaining bracket in vise and file / grind approx 1/8″ off protruding tab. (see Figure 5A)
Which is the best tunnel ram linkage kit?
While our pro tunnel-ram linkage kits utilize aircraft quality components for precise opening and closing rates.
