Easy lifehacks

Are caster camber plates necessary?

Are caster camber plates necessary?

Aftermarket caster camber plates are only really needed when dropping your Mustang or making other radical front end changes that would otherwise put wheel alignment out of spec and out of range of the factory serviceability.

How do caster camber plates work?

Camber caster plates are designed to add static, or permanent, positive or negative camber to a vehicle in order to expand the range of camber that it’s capable of reaching. Many aftermarket camber caster plate sets will also mount higher on the strut, increasing strut travel.

What is the purpose of camber plates?

What is a camber plate? Camber plates are basically an adjustable adapter for your shocks. They install usually on top of the strut and allow for fine camber adjustments. Camber plates are available for most car/suspension set-ups.

Do lowering springs cause camber?

The Suspension gains positive camber as it is unloaded, or lifted, typically seen only on trucks or Jeeps. On average most cars gain about -0.75 degrees of camber with every inch it is lowered, which adds up very quickly.

What is positive camber?

It is used in the design of steering and suspension. If the top of the wheel is farther out than the bottom (that is, away from the axle), it is called positive camber; if the bottom of the wheel is farther out than the top, it is called negative camber.

Do you need an alignment after adjusting camber plates?

The manufacturer was kind enough to allow for some adjustment to correct for camber differences from the factory but sometimes it isn’t enough. We always recommend getting an alignment after a suspension installation. But if you leave the alignment shop wanting more or less camber there are a few options.

How long does it take to install camber plates?

The typical installation time is under 2 hours (not including a front end alignment).

How much camber do camber plates give you?

In general, most performance suspension setups benefit from anywhere between -1 and -2.5 camber.

Do tie rods affect camber?

If you back up, the TTB will show negative camber. If the toe is too far OUT now from the tie rods the ttb will show negative camber under forward driving. Too far toed IN on the TTB will produce positive camber. Get it aligned, you don’t need camber bushings.

Author Image
Ruth Doyle