How to replace headlights 10-12 GMC Acadia?

If playback doesn’t begin shortly, try restarting your device. Videos you watch may be added to the TV’s watch history and influence TV recommendations. To avoid this, cancel and sign in to YouTube on your computer. An error occurred. Please try again later. (Playback ID: eU3ctskb2YB6hNkl)

How to remove the front bumper and headlight housing?

Remove the 5 screws on the front most half of the fender well. You do not need to completely remove the inner fender well for this guide. Remove the two screws on the uderside of the bumper holding the Fender well to the bottom. Also remove the one 10mm bolt holding the bumper to the lower frame.

How to remove front bumper on GMC Acadia?

Also remove the one 10mm bolt holding the bumper to the lower frame. Open the Hood and start to remove the 6 push pins and two screws holding the upper dust shield in place. This is where the push pin tool would be helpful but a broad tip flathead will also work to pop the pins.

How do you remove a headlight from a car?

There are 2 push pins and 4 screws along the front grill portion where it connects to the radiator support and to the headlight itself. You can also remove the two 10mm bolts on each headlight housing holding it to the frame. You can now remove the wheel arch moulding form each side of the fender and bumper.

Where to put the adjuster on a GMC Terrain headlight?

Aiming is easy. Just gotta pop that top cover off that’s covering the top of the headlight and stick a 10mm wrench down the back, you can see the adjuster screw easy. Aimin is usually 2″ below the center of the light at 25′ from the wall

How to replace headlights 10-12 GMC Acadia?