What should the thermostat be on a Camaro?

What should the thermostat be on a Camaro?

I borrowed a temperature gun from my father (it’s made for food by the way) and after driving the car around for about 15 minutes in 90 degree heat both the upper and lower radiator hoses read about 10 degrees apart from each other, lower one being about 168 degrees and the upper being 175.

Who is the manufacturer of the control 4 thermostat?

The Control4 Wireless Thermostat by Aprilaire was jointly developed with the climate control experts at Aprilaire to deliver a reliable and sophisticated thermostat that consistently delivers the right level of comfort in the most efficient way possible.

How to reset service reminders on Control4 thermostat?

When prompted to Service Reminders, press the or button to select Yes, then press button (Next). Press or button to select Yes for each reminder you would like to reset. Press button (Next) to go to the next reminder or button (Back) to go to a previous reminder. Press button (Done) to reset the selected service reminders.

How to set the thermostat to heat or cool?

Select system mode (Em Heat/Heat/Off/Cool/Auto) Press button to select: Em Heat: (only for heat pumps with auxiliary heat) Thermostat controls auxiliary heat. Heat pump will not operate in Em Heat mode. Heat: Thermostat controls only the heating system. Off: Heating and cooling systems are off. Cool: Thermostat controls only the cooling system.

How do you change the thermostat on a 350Z car?

Slide the top radiator hose back onto the inlet port of the thermostat housing. Slide the hose clamp back over the hose and the inlet port of the thermostat housing. Tighten the hose clamp down tight with the flat-head screwdriver. Fill the radiator back up with antifreeze coolant until the radiator is full. Start the engine and let it idle.

How do you replace the thermostat on a corvette?

When the thermostat housing is reattached, do NOT use RTV silicone. The o-ring on the new thermostat will provide a sufficient seal. Using the reverse process from above, secure the thermostat housing with two bolts and attach the radiator hose back. Figure 4a.

How do you change the bottom of a thermostat?

Put the new thermostat in the same way the old one came out. Apply a very small amount of the red high temperature silicone to the bottom of the thermostat housing. Then, match the three holes on the new gasket with the three holes on the bottom of the thermostat and press the new gasket onto the bottom of the thermostat housing.

How do you remove a thermostat from an engine?

Pull the top half of the thermostat housing off of the top of the engine block. Slide the thermostat out of the top of the engine block, noting its orientation. Scrape any old gasket material off of both mating surfaces, using a gasket scraper or flat-head screwdriver. Be sure that both surfaces are clean.