Common questions

What should I do if my long crank wont start?

What should I do if my long crank wont start?

Just a recap of what you should do first to determine if your long crank before starting is fuel related or not. First, before you try cranking the engine over, turn the ignition key to the run position then back off without cranking the starter.

What does no click no crank mean on a car?

No-Click No-Crank: When this occurs, power is not being sent to the solenoid, making it very unlikely that the issue is related to the starter motor. If all systems have been checked, and the starter is found to be the cause, the ring gear also should be inspected for damage that could cause future starter damage.

What’s the difference between slow crank and crank no crank?

Slow Crank: The starter will crank, however, the engine RPM is slow to start the vehicle. Click No-Crank: The solenoid clicks but the starter doesn’t crank. No-Click No-Crank: The solenoid doesn’t click and the starter doesn’t crank. Once you’ve identified which problem you’re dealing with,…

How to diagnose a cranking starter problem?

While cranking problems can be frustrating, identifying and correcting the root cause does not have to be. The first step is to identify the symptoms. In a cranking system, you can divide your symptoms into one of three possible troubleshooting categories: Slow Crank: The starter will crank, however, the engine RPM is slow to start the vehicle.

Just a recap of what you should do first to determine if your long crank before starting is fuel related or not. First, before you try cranking the engine over, turn the ignition key to the run position then back off without cranking the starter.

What causes engine crank time to be extended?

Another common reason for extended crank time for engines is a vacuum leak. Engine vacuum must be a sealed system which the mass air flow and map sensors depend on to send feedback information to the main computer which in turn sets the stage for the engine starting sequence.

What causes a Chevy pickup to hard start?

If after you have circled the key a few time the engine starts normally then you now know for sure you have a fuel pressure leak down problem causing your hard start. If this video was helpful please help support my youtube channel by subscribing here: https://www.youtube.com/channel/UChCX…

Can a bad crankshaft sensor cause the engine to stall?

If the crankshaft position sensor or its wiring have any issues, it can cause the crankshaft signal to be cut off while the engine is running, which can cause the engine to stall. This is usually a symptom of a wiring problem, however a bad crankshaft position sensor can also produce this symptom.

Can a 1997 Chevy c1500 5.7L start?

1997 Chevy C1500, 2WD, 5.7L won’t start – cranks fine. No codes – good fuel pressure ( 60+ psi – new pump), good spark, 1997 Chevy C1500, 2WD, 5.7L wont start – cranks fine. No… It will not start. I changed the fuel filter and fuel pump It will not start.

Why is my truck slow to crank when warm?

This prignition would force the piston down and rotate the crankshaft in the opposite direction that the starter motor was turning the engine over. However, this would be unlikely in a vehicle with fuel injection.

Why does my GM car say no start no crank?

How to diagnose a no start no click on GM vehicle. If you have a late model GM vehicle and turn the key only to hear nothing, you’ll most likely think you have a dead battery—and you may. But a no start, no crank, no click condition can be far more involved than that.

What should I do before cranking the engine over?

First, before you try cranking the engine over, turn the ignition key to the run position then back off without cranking the starter. What this will do is run the fuel pump and in most cases, you will be able to hear the fuel pump running. Do this 3 to 4 times before you try starting it.

Why does my Chevy Express van not start?

Lately I have had this problem: Go to start the van and if fires up for about one second then quits. Try and try it will not start. Dealer at first said it was the fuel pump. Replaced it. Months later still doing the same thing. It like the security system is telling the car not to start.

What’s the long cranking time on a 2006 suburban?

Post: Long cranking time. Hard start (Topic#230127) 2006 Suburban 5.3 turns over awhile before starting up. Runs fine once started. I do not see a fuel pressure regulator nor do I see one listed at Rock auto parts.

What causes a Chevy Silverado 1500 to hard start?

As it warms up the idle air control adjusts to this vacuum leak and when the key is off the idle air control resets itself causing a hard start up due to the vacuum leak not being compensated for. Just a possibility 16 people found this helpful. K6, see what I mean by listen to John?

What causes engine to crank for long time before it starts?

When an engine cranks for a long time before it starts, either spark or fuel is missing or weak and each has its own reasons. Most of the time, the air / fuel mixture has been disturbed and there is too much air or not enough fuel.

Why is my Chevelle 350 hard to start?

Fuel pump check valve doesn’t maintain pressure in the fuel rail so it boils and then you have to crank excessively to get rid of the vapor before it will start. Bought a 1972 Chevelle 350 a couple years ago. Every time I drove it it wouldn’t restart easily or sometimes not at all unless I waited a while.

If after you have circled the key a few time the engine starts normally then you now know for sure you have a fuel pressure leak down problem causing your hard start. If this video was helpful please help support my youtube channel by subscribing here: https://www.youtube.com/channel/UChCX…

Why is my car engine hard to crank over when hot?

The starter (which is warm anyway from the engine heat) no gets even more heat from the exhaust (usually headers but sometime the “Y” pipe). The hotter the starter the higher the electrical resistance = starter won’t run as fast as it should.

When does the long crank start on a Cummins?

Long….. Long Crank when starting Long….. Long Crank when starting Location:Vancouver, WA. Need your help. I started having the long crank issue 2 months ago. I was still on the original batteries and had read somewhere that as they go they will still turn the engine over but not have enough to send the signal to the fuel system.

Long….. Long Crank when starting Long….. Long Crank when starting Location:Vancouver, WA. Need your help. I started having the long crank issue 2 months ago. I was still on the original batteries and had read somewhere that as they go they will still turn the engine over but not have enough to send the signal to the fuel system.

What to do if your Dodge Nitro won’t start?

When you come back to the Nitro, put the key in and turn it to the “Run” position but do not start it! In this position the fuel pump and other electrical components will run.

Why does my Jeep start with a long crank?

But one symptom of eroded away spark plugs is hard starting and longer cranking. There is a residual pressure valve in the fuel system, unfortunately it is usually in the fuel pump. This valve traps pressure in the fuel system when you shut off the engine, for the next restart, so you have full pressure in the fuel system as it starts.

What does it mean when a jeep cranks up?

Then put your foot on the brake and press the pushbutton again, and it will crank, if it start right up, that’s a big sign fuel pressure is bleeding down to much after the engine is shutoff.

Why do I get full fuel delivery when I crank?

So, if your fuel system is working right and retaining full fuel pressure after its shut off, then you’d get full fuel delivery from the injectors as you crank.

Why is my engine hard to start or extended cranking?

So if the engine is warm or cold, this sponge has to be saturated and begin to drip before the engine will start and extended cranking is one of the classic symptoms. By trying the fuel additive and thinking of this as a diagnostic procedure, if your problem gets better, continue to use the fuel additive. No change, stop using the additive.

Why does it take so long to start a 300K engine?

Sure why not. On high mileage engines (200k to 300k) the pistons ring can wear causing low compression which increases crank time and causes hard starting. This is because the compression ratio is low and it takes time for the engine to gain enough speed cranking by the starter to ignite the fuel air mixture.

So if the engine is warm or cold, this sponge has to be saturated and begin to drip before the engine will start and extended cranking is one of the classic symptoms. By trying the fuel additive and thinking of this as a diagnostic procedure, if your problem gets better, continue to use the fuel additive. No change, stop using the additive.

First, before you try cranking the engine over, turn the ignition key to the run position then back off without cranking the starter. What this will do is run the fuel pump and in most cases, you will be able to hear the fuel pump running. Do this 3 to 4 times before you try starting it.

Why is my Salem Boys car so hard to start?

A bad coolant sensor, a bad throttle position sensor (TPS), a bad fuel pump or a plugged fuel filter can all cause a lean condition causing long cranking times. Sometimes the spark is delivered late, weak or not at all.

What’s the difference between hard starting and long cranking periods?

My 06′ 2500 4×4 straight drive, 5.9 cummins starts usually within 2-3 seconds max, but every now and then it will crank forever and not start until the key is released and tried again. And the second try it will start but only after cranking for a lond period of time (5-10 seconds).

What should I do if my fuel pump keeps cranking?

Once you hear the pump turn off, try to start the rig. Let us know if it starts normally, or if there is still an extended cranking. You can also do the same thing before a cold start, and compare how long the fuel pump runs. Recently had that problem.

What causes a car to have a hard start?

This guide will help by starting with simple fixes and conclude with the more difficult. What goes wrong? Normal wear and usage can cause a hard start condition due to lack of fuel pressure, poor intake air management, false readings to the car’s computer or weak spark.

Another common reason for extended crank time for engines is a vacuum leak. Engine vacuum must be a sealed system which the mass air flow and map sensors depend on to send feedback information to the main computer which in turn sets the stage for the engine starting sequence.

Sure why not. On high mileage engines (200k to 300k) the pistons ring can wear causing low compression which increases crank time and causes hard starting. This is because the compression ratio is low and it takes time for the engine to gain enough speed cranking by the starter to ignite the fuel air mixture.

Why does my car not start when I crank the engine?

If the engine doesn’t crank, or makes an unusual noise when cranking, you may have a starting system problem. The car’s security system may have made an error that disabled the fuel or ignition system, or the chip in the key may have failed.

What does it mean when your engine cranks but fails to start?

When your engine cranks but, fails to start. It usually means your engine is having trouble producing a spark, getting fuel, or creating compression. But, what if, ignition, fuel, and compression were all checked and are all working good. So, what can you do when your engine cranks but fails to start.

What to look for when your engine won’t start?

Check for a blown fuse that may be preventing a circuit from working properly, like the fuel injection or computer system. To operate efficiently, an internal combustion gasoline engine needs a good spark, the right amount of fuel, and good compression (a healthy mechanical condition).

What makes an internal combustion engine not start?

To operate efficiently, an internal combustion gasoline engine needs a good spark, the right amount of fuel, and good compression (a healthy mechanical condition). The lack of any of these three things will prevent your engine from starting.

Why does my car not start when I Turn on the engine?

False input or lack of input from sensors like the crankshaft position sensor (CKP) or camshaft position sensor (CPS) can prevent the engine from starting. Also, a bad throttle position sensor (TPS) may cut off the spark to the cylinders. Battery.

When do I go to crank my car the key stays in the start Posi?

Q: When I go to crank my car the key stays in the start position and the car is constantly trying to crank itself. When I place the key in the ignition and proceed to crank the car the key stays in the start position and the car is constantly trying to start itself up but never actually turns over.

Why does my Car Crank when I turn the key?

That’s correct. The car has never failed to crank when I turn the key. It just cranks for longer before starting if it sits for a few hours (temperature dependent – longer crank when cold outside, less so when warm).

How long do you have to crank the engine before the engine starts?

On two separate occasions in the last couple of months, I had to crank the engine for a long time (30 seconds or more) before the engine would start. After each of these occasions, it began starting normally again until my recent problem.

What causes a car to not start when cranking?

The glow plug circuit will not cause a no start. P0381 is a glow plug indicator lamp circuit code. P1670 indicates a possible fault in the EF (electronic feedback) circuit between the PCM and IDM, and is not a camshaft position sensor code. That code is often set after cranking with low battery voltage.

Author Image
Ruth Doyle