What are the parts of EOT crane?

What are the parts of EOT crane?

Parts of EOT Cranes

• Hoist. – The hoist is what creates the lift in lifting systems by holding, raising, or lowering the load using wire rope or chains.
• Trolley. – Trolley’s support the hoist and moves along the crane’s bridge.
• Bridge.
• Columns.
• Runway.
• End Effectors.
• Reinforced-steel cable.
• Hook.

What are crane supports called?

The most recognizable part of any crane is the boom. This is the steel arm of the crane that holds the load. Rising up from just behind the operator’s cab, the boom is the essential piece of a crane, allowing the machine to raise loads to heights of several dozen feet.

What is LT and CT in Crane?

LT motion : Long Travel Motion. CT motion : Cross Travel Motion. Bridge : the structural portion on which the trolley/crab moves. LT End carriage : Structure which houses Long Travel Wheels. CT End carriage : Structure which houses Cross Travel Wheels.

What is DSL in EOT crane?

Direct Supply Line (DSL) refers to Angle Iron bus bars, supported on insulators, arranged length wise, at a safe height, in open to provide electric supply to EOT (Electric Overhead Travel) Cranes.

What is parts of crane any 5 parts?

Crane Parts and Functions

1. The Hook. This may be one of the most recognizable and important parts of a construction crane.
2. Wire Rope and Sheaves. Cranes use heavy-duty wire ropes to lift extreme loads.
3. The Boom.
4. Counterweights.
5. Outriggers.
6. Wheels and Tracks.
7. The Hoist.
8. The Jib.

What is a crane model?

Cranes are traditionally used in the construction industry or where there is a need to move heavy items. A model crane can be built using simple craft items and supplies from around the home. This model can be built with either a magnet or hook.

What is an electromagnetic crane?

Magnet Crane Also referred to as electromagnetic cranes, these cranes are used to handle and move metals like steel and iron. Magnet cranes can be found mostly in recycling plants and scrap yards. They operate using a magnetic field that is formed by an electric current passing through windings around the magnet.

What are the parts of an EOT crane?

EOT crane bridge frame: consists of two main beams, two end beams, walkway, railings and other component parts. Its structure including two: box type overhead crane and truss type overhead crane. 2. EOT crane traveling mechanism: consists of motor, brake, reducer, coupling, transmission shaft, angle bearing box, wheels and other component parts.

Where are the end trucks on a crane?

End Trucks – These are located on either side of the bridge and consist of the assembly on which the entire crane travels. The assembly consisting of structural members, wheels, bearings, axles, electric drive motors, etc.

How is an overhead crane like a monorail?

Monorail – These cranes generally consist of a hoist supported by a single I beam with long travel motion of the bridge. Bridge / Girder – It is one of the principal structural components of an overhead crane which spans the width of the building. The bridge carries the hoist which travels along the length of the girders during operation.

Which is the best manufacturer of crane parts?

CMK ELECTROPOWER (P) LIMITED has today emerged as one of the most noted manufacturers, exporters suppliers, with specialization in offering a complete range of Material Handling and Crane Control Equipments.