What should I do about the error code p0488?
What should I do about the error code p0488?
AutoDoktor OBD2 is showing only code P0488. (EGR Throttle position circuit) After replacing of the EGR unit the same error appears. Clear the DTC doesn’t help. The code is gone for a few seconds and comes back immediatelly. T… I have an error code P0488 from diagnostics. What should I do to fix this error.
What causes a P1000 Ford engine to fail?
P1000 FORD Possible Causes 1 The vehicle is new from the factory. 2 Battery or Powertrain Control Module (PCM) had recently been disconnected. 3 An OBD monitor failure occurred before completion of an OBD drive cycle. 4 PCM Diagnostic Trouble Codes (DTC) have recently been cleared with a scan tool. More …
Why is my p0488 EGR throttle control valve not working?
If all prior tests have passed and you continue to get a P0488, this would most likely indicate a failed EGR throttle control valve, although a failed PCM could not be ruled out until the EGR throttle control valve had been replaced.
Why does my Ford P1000 have a DTC code?
Battery or Powertrain Control Module (PCM) had recently been disconnected. An OBD monitor failure occurred before completion of an OBD drive cycle. PCM Diagnostic Trouble Codes (DTC) have recently been cleared with a scan tool. How is the P1000 FORD code repair? Start by checking the “Possible Causes” listed above.
P1000 FORD Possible Causes 1 The vehicle is new from the factory. 2 Battery or Powertrain Control Module (PCM) had recently been disconnected. 3 An OBD monitor failure occurred before completion of an OBD drive cycle. 4 PCM Diagnostic Trouble Codes (DTC) have recently been cleared with a scan tool. More
What are the symptoms of a p0488 engine code?
Symptoms of a P0488 engine code may include: Longer than normal active aftertreatment regeneration times (it will take longer for the exhaust system to get hot and burn off the soot that has built up inside the diesel particulate filter/catalytic converter) Potential causes for this code to set are:
Battery or Powertrain Control Module (PCM) had recently been disconnected. An OBD monitor failure occurred before completion of an OBD drive cycle. PCM Diagnostic Trouble Codes (DTC) have recently been cleared with a scan tool. How is the P1000 FORD code repair? Start by checking the “Possible Causes” listed above.
If all prior tests have passed and you continue to get a P0488, this would most likely indicate a failed EGR throttle control valve, although a failed PCM could not be ruled out until the EGR throttle control valve had been replaced.
