Is there wheel bearing for Ford Focus Mk2?
Is there wheel bearing for Ford Focus Mk2?
I have done a wheel bearing for the front of a Mk2 Focus but don’t recognise the parts you refer to here. There were no Ford special tools used, just a bench fly press, some bodged bits and lots of force by two of us heaving on the press.
How to replace a wheel bearing on a Ford?
1 If the wheel hub is very worn, the hub may fall off into your hands after you start wiggling it. 2 Attach the hub puller tool to the wheel hub using the wheel lugs. Secure the hub puller tool with the lug nuts. 3 Apply fast, hard tugs with the slide hammer to pull the wheel hub away from the wheel bearing’s center race. …
Which is Ford special tool 204-348 for wheel hub bearing?
I usually use the Haynes guide for my repairs, I have all the tools to do the job except for the ‘Ford Special Tool 204-348 (https://fordspecialtools.service-solutions.com/en-US/Pages/ItemDetail.aspx?SKU=204-348) mentioned.
What to do with wheel hub bearing special tool?
When refitting the bearing you must only apply the force to the outer race which is usually a press fit into the hub. Pushing in the bearing by loading the inner race will result in early failure once installed. The load is transmitted through the ball race and is much greater than it is designed to take.
When do you need to replace wheel bearing on Ford Focus?
The wheel bearing is a self-contained unit on the wheel of the Ford Focus. This means the bearing doesn’t get lubricated during the normal grease and lube routine because it is a sealed bearing. While it doesn’t happen very often, sometimes a bearings goes bad and you need to replace it.
How do you remove wheel from Ford Focus?
Place a jack stand under the frame near the jacking point and raise the jack stand as close as possible to the frame of the car. Remove the wheel using the lug wrench. Remove the hub retainer nut by twisting it off the axle by hand, then remove the brake caliper using a ratchet and the proper size socket.
Where is the wheel nut on a Ford Focus?
Park the car on a level surface and place the wheel chocks behind the rear wheels. Loosen the center nut on the wheel axle using a socket and ratchet, but do not remove it yet. Open the engine compartment and loosen the center nut on the strut shaft.
How do you remove a wheel bearing from a Ford?
Remove the suspension strut bolt from the steering knuckle. Apply hammer blows to the top of the steering knuckle to separate the knuckle away from the suspension strut. Pull the CV axle shaft away from the steering knuckle hole. Remove the snap ring out of the snap ring groove of the steering knuckle. 4. Removing the Bearing
