What to do if you have a leak in the drive shaft?
What to do if you have a leak in the drive shaft?
The small hole was repaired with JB weld available from most auto parts and hardware stores. This can be accomplished by removing the yoke from the drive shaft, cleaning the area thoroughly; mixing the two-part JB weld and completely covering the plug area face up. The JB weld will flow out smoothly and harden providing an oil resistant seal.
Where is the leak in the transmission shaft?
Photo # 1 shows the yoke plug. Our inspection discovered the plug that seals the end of the yoke had a small rust hole from the inside out. As the fluid traveled down the output shaft and yoke splines it leaked through the holes in this plug.
What causes a leak at the drive shaft yoke?
As you can see, its much more obvious from this view that there is a larger area of surface oxidation on the inside of the yoke plug that could cause a much larger leak if left untreated. Photo # 3 shows the repair after the JB weld was applied and hardened.
Why is fluid leaking from the rear of my Thunderbird?
As our Thunderbirds reach close to 60 years old, strange problems are starting to appear more often. Recently I encountered a situation where fluid was leaking from the rear of the transmission. The owner thinking it was the rear seal at the output shaft housing – replaced the seal.
The small hole was repaired with JB weld available from most auto parts and hardware stores. This can be accomplished by removing the yoke from the drive shaft, cleaning the area thoroughly; mixing the two-part JB weld and completely covering the plug area face up. The JB weld will flow out smoothly and harden providing an oil resistant seal.
Photo # 1 shows the yoke plug. Our inspection discovered the plug that seals the end of the yoke had a small rust hole from the inside out. As the fluid traveled down the output shaft and yoke splines it leaked through the holes in this plug.
As you can see, its much more obvious from this view that there is a larger area of surface oxidation on the inside of the yoke plug that could cause a much larger leak if left untreated. Photo # 3 shows the repair after the JB weld was applied and hardened.
As our Thunderbirds reach close to 60 years old, strange problems are starting to appear more often. Recently I encountered a situation where fluid was leaking from the rear of the transmission. The owner thinking it was the rear seal at the output shaft housing – replaced the seal.
How do you replace a seal on a Chevy truck?
Drive the seal into the bore with a seal driver and hammer than slide the yoke back onto the pinion shaft, making sure the marks you made on the yoke and shaft align. Install the pinion nut and tighten it, seating the yoke on the shaft.
How do you remove a front slip yoke drive shaft?
If you have a front slip yoke drive shaft, remove the bolts to the drive shaft on the rear axle. Use a large flat screwdriver and slightly pry out the drive shaft and universal joint from the yoke on the axle.
What causes oil to leak from output shaft seal?
When the seal is hard, bending the seal will allow fluid to escape the transfer case and allow dirt, debris, and water to enter into the transfer case. The most common sign of output shaft seal failure is the drip of gear oil leaking from the seal.
