What are the diagnostic codes for a Cadillac?

What are the diagnostic codes for a Cadillac?

P0503 . Vehicle Speed Sensor Noisy P0504 . Brake Switch A/B Correlation P0505 . Idle Ctrl Sys Error P0506 . Idle Ctrl Sys RPM Lower Than Expected P0507 . Idle Ctrl Sys RPM Higher Than Expected P0551 . Power Steering Pres Sensor Circ Range/Perf P0560 . Sys Voltage Error P0562 . Sys Voltage Lo P0571 . Cruise Ctrl/Brake Switch A Circ Fail P0603 .

What are the P codes for an engine?

P0012 Camshaft position (CMP), intake/left/front, bank 1 timing over -retarded Valve timing, engine mechanical fault, CMP actuator P0013 Camshaft position (CMP) actuator, exhaust/right/rear, bank 1 -circuit malfunction Wiring, CMP actuator, ECM

What are the P codes for mechanical fault?

P0016 Crankshaft position/camshaft position, bank 1 sensor A -correlation Wiring, CKP sensor, CMP sensor, mechanical fault P0017 Crankshaft position/camshaft position, bank 1 sensor B -correlation Wiring, CKP sensor, CMP sensor, mechanical fault

What is the p code for a fuel volume regulator?

P0001 Fuel volume regulator control -circuit open Wiring, regulator control solenoid P0002 Fuel volume regulator control -circuit range/performance Wiring, regulator control solenoid P0003 Fuel volume regulator control -circuit low Wiring short to earth, regulator control solenoid P0004

What causes the p0174 code on a Cadillac?

If the problem persists the front oxygen (O2) sensor may need to be replaced. The P0174 code could also be caused may be caused by one or more of the following: debris on the MAF sensor causing an incorrect reading, improper oil level, low or high fuel pressure, or Engine Control Temperature (ECT) Sensor reading inaccurate.

What does the OBD-II code p0147 mean?

P0147 is the OBD-II generic code indicating the Engine Control Module (ECM) has tested the O2 sensor heater circuit during startup and detects problems with the bank 1 sensor 3 O2 sensor heater circuit. What causes the P0147 code? The ECM tests the O2 sensor heater circuits at startup for excessive current draw, opens, or shorts.

When to use p0047 boost control solenoid code?

Code P0047 is set when the PCM detects a low boost control solenoid signal, no matter if the engine uses a VGT turbo or traditional turbocharger/supercharger. One style of turbocharger boost control solenoid valve: P0045 Turbocharger/Supercharger Boost Control “A” Circuit/Open

When to set p0047 on a turbocharger?

In reference to this trouble code, the “A” indicates the problem in with a portion of the system circuit, instead of a particular symptom or component. Code P0047 is set when the PCM detects a low boost control solenoid signal, no matter if the engine uses a VGT turbo or traditional turbocharger/supercharger.