What does CL mean on fuel system?
What does CL mean on fuel system?
Fuel system : CL -Fault (closed loop fault )
What is fuel system 1 Cl and Ol-drive?
What is fuel system 1 cl and ol-drive? Increase on fuel yes. i hooked my zurich zr13 reader. Code PO174. I open my hood and notice that my air intake tube was detached from air filter box. I have fixed … read more Vocational, Technical or Tra… Car stalls on idle. if i give it some gas it keeps running. Vocational, Technical or Tra…
What is the status of the open loop fuel system?
• Open loop fuel system statusOpen loop fuel system status due to fault status with all the upstream oxygen sensors • It appears that Closed loop- fault will occur first then thisfault will occur first, then this status will appear second Open Loop-Fault 2 Upstream sensors shorted to ground Note: Closed Loop-fault appeared First Opppen Loop-Drive
How does fuel system change from CL to CL-fault?
Fuel system is changing from CL to CL-fault. 4 seconds in CL-fault and about 15 seconds in CL. While in CL-fault the LTFT on bank 1 and 2 is 25, O2 sensor voltages seem normal and the idle is smooth. While in CL the LTFT on bank 2 only is 2.3, O2 sensor voltages are near zero and the idle is rough. MAF is .5v in both conditions.
What is the fuel system on demand code?
The vehicle’s PID data was watched very closely as it warmed up. After closed loop operation was obtained, it was noted that both upstream oxygen sensors went well below 0.5 volts and remained there. The fuel system status then went to open loop fault. A review of scan tool data shows a code P1131 and P1151 stored as “On Demand Codes.”
Fuel system is changing from CL to CL-fault. 4 seconds in CL-fault and about 15 seconds in CL. While in CL-fault the LTFT on bank 1 and 2 is 25, O2 sensor voltages seem normal and the idle is smooth. While in CL the LTFT on bank 2 only is 2.3, O2 sensor voltages are near zero and the idle is rough. MAF is .5v in both conditions.
When to use open loop or closed loop fuel control?
Open loop STFT is used on some PCM’s when the O2 sensors are showing signs of operation (O2 Readiness), however the closed loop enable ECT has not been reached. In this mode the STFT’s may function. The final mode is Closed Loop and in this mode the full closed loop fuel controller is operational.
The vehicle’s PID data was watched very closely as it warmed up. After closed loop operation was obtained, it was noted that both upstream oxygen sensors went well below 0.5 volts and remained there. The fuel system status then went to open loop fault. A review of scan tool data shows a code P1131 and P1151 stored as “On Demand Codes.”
What should fuel system 1 and fuel system 2 status be?
Fuel System 1 Status and Fuel System 2 Status should be in closed-loop (CL). If the PCM is not able to achieve CL, the fuel trim data may not be accurate. Engine Coolant Temperature (ECT) should reach operating temperature, preferably 190°F or higher.