How do you remove an axle from a Posi?
How do you remove an axle from a Posi?
Catch the oil in a pan, and dispose of it properly at a recycling center. Remove the differential cover by removing the bolts around the perimeter of the cover. Catch any remaining oil in the oil pan. Unbolt and remove accessible parts from the differential. Some of the internals are not accessible until the axles are removed in the next step.
How do you upgrade a Posi Traction differential?
Unbolt the remaining internals from the differential and remove the rest of the internals. Unclip the retention ring on the pinion gear that is attached to the drive shaft, and remove the pinion gear too. Install the new internals in the reverse order. Bolt the posi-traction upgrade kit into place.
How to remove rear axle shafts with locking differential?
On axles WITH a locking differential, keep the pinion shaft partially withdrawn. 16. On axles WITH a locking differential, place the C-lock (1) on the axle shaft (3) so that the ends are flush with the thrust block (2) (Illistation # 8).
Where are Positraction and limited slip differentials located?
by Mona Prestenbach. Positraction and limited-slip are both types of automotive differentials. Differentials are located in the center of the front axle, center of the rear axle or, in some cases, both. Differentials are designed to assist tires in turning at different speeds.
Do you have to remove rear axle shafts?
This is what I used to replace my rear dust shields. This procedure can be used for that as well as axle replacement, parking brake replacement, or anything in which you have to remove the axle. I am at work currently, so I can not upload my color pictures.
Is the posi traction a limited slip differential?
Posi-Traction is a limited-slip design, and over time, the clutches wear out and function essentially as an open carrier. Another simple test is to jack up the back of the vehicle with the wheels off the ground and the trans-mission in neutral.
How to remove pinion seal from Chevy differential?
Pinion Yoke Removal 1 Remove Pinion Nut A fair amount of torque is required for removing the pinion nut. 2 Remove Yoke A few blows with a soft hammer usually gets the yoke free from the splines. 3 Remove Pinion Seal (Special Tool)
What kind of carrier does a Posi Traction clutch use?
There are several ways to answer this question. Most gearheads use the common burnout method: Do a burnout, and if you get two black stripes, you have a working Posi-Traction carrier. This doesn’t always work, however. Posi-Traction is a limited-slip design, and over time, the clutches wear out and function essentially as an open carrier.
