How do you replace tail light bulbs on a Fiat 500?
How do you replace tail light bulbs on a Fiat 500?
Re-insert the four T25 screws and tighten them in the clockwise direction. Hold the tail light housing near the rear corner of the vehicle and push the power plug back in to place. Line up the metal pegs on the back of the housing with their corresponding grommets on the rear of the car. Push the tail light housing back in to place.
Can a burnt out tail light bulb be replaced?
How to change a burnt out brake, rear turn signal or reverse bulb in the tail light housings of a 2008-2015 Fiat 500.
How to replace rear turn signal light bulb?
Push the old rear turn signal light bulb down in to the socket and rotate it 1/4 turn counterclockwise before pulling it straight out. Push a new amber colored # PY21W bulb down in to the socket and rotate it 1/4 turn clockwise to secure it in place.
How are tail light bulbs held in place?
The tail light housing is still held in place by two metal pegs or “spikes” on the outer edge of the assembly that act as friction fasteners inside plastic grommets on the rear corner of the vehicle.
Re-insert the four T25 screws and tighten them in the clockwise direction. Hold the tail light housing near the rear corner of the vehicle and push the power plug back in to place. Line up the metal pegs on the back of the housing with their corresponding grommets on the rear of the car. Push the tail light housing back in to place.
How to change a burnt out brake, rear turn signal or reverse bulb in the tail light housings of a 2008-2015 Fiat 500.
How do you change the tail lights on a car?
Once you have done this, you’ll need to access the tail lights through the trunk or rear hatch. It will be helpful to do this in a well-lit place, or you can grab a flashlight. There could be extra carpet or padding in the way of the access point. Move these away until you can easily see the back of the taillights.
Push the old rear turn signal light bulb down in to the socket and rotate it 1/4 turn counterclockwise before pulling it straight out. Push a new amber colored # PY21W bulb down in to the socket and rotate it 1/4 turn clockwise to secure it in place.
