Where is the resistor on a Chevy Colorado?
Where is the resistor on a Chevy Colorado?
You mention it’s not the resistor but you don’t mention if you changed it out or not. Sounds like the motor is good because it runs when you jumped the ground wire. The ground for it is on the passenger side fender behind the air box.
Where is the blower located on a Chevy Colorado?
If you don’t have any blower operation at all, it is most likely something other than the resistor module. The high speed circuit bypasses the resistor module. As mentioned above, there are other connectors, in the circuit, that have been problematic. One mounted on the HVAC case, behind the glove box, and one behind the right kick panel.
Where is the compressor ground on a Chevy Colorado?
The compressor ground is G103, on the engine block. If you don’t have any blower operation at all, it is most likely something other than the resistor module. The high speed circuit bypasses the resistor module.
Where is the HVAC control module on a Chevy Colorado?
One mounted on the HVAC case, behind the glove box, and one behind the right kick panel. They are both inline connectors. To get access to the HVAC Control Module you will have to remove the trim panel around it. It is just retained by some spring clips, so you can just pry it off with a flat tool.
You mention it’s not the resistor but you don’t mention if you changed it out or not. Sounds like the motor is good because it runs when you jumped the ground wire. The ground for it is on the passenger side fender behind the air box.
If you don’t have any blower operation at all, it is most likely something other than the resistor module. The high speed circuit bypasses the resistor module. As mentioned above, there are other connectors, in the circuit, that have been problematic. One mounted on the HVAC case, behind the glove box, and one behind the right kick panel.
The compressor ground is G103, on the engine block. If you don’t have any blower operation at all, it is most likely something other than the resistor module. The high speed circuit bypasses the resistor module.
One mounted on the HVAC case, behind the glove box, and one behind the right kick panel. They are both inline connectors. To get access to the HVAC Control Module you will have to remove the trim panel around it. It is just retained by some spring clips, so you can just pry it off with a flat tool.
