When did the Chevy Caprice get the LT1 engine?

In 1994, Chevrolet equipped the 9C1 Caprice with a version of its LT1 engine, the same motor used in that year’s Corvette sports car. Chevrolet continued to install the LT1 until 1996.

How much horsepower does a 9C1 Caprice have?

When was the first Chevy Caprice Police Interceptor made?

From 1986 to 1996, Chevrolet manufactured a Police Interceptor model of its Caprice for use by law enforcement agencies. The company referred to this version as the 9C1.

How tall is a 9C1 Caprice police car?

The 9C1 Caprice stood 55.7 inches in height and had a width of 77 inches. Although Chevrolet built the 9C1 on its standard Caprice chassis, it used a thicker, higher-grade steel.

In 1994, Chevrolet equipped the 9C1 Caprice with a version of its LT1 engine, the same motor used in that year’s Corvette sports car. Chevrolet continued to install the LT1 until 1996.

From 1986 to 1996, Chevrolet manufactured a Police Interceptor model of its Caprice for use by law enforcement agencies. The company referred to this version as the 9C1.

The 9C1 Caprice stood 55.7 inches in height and had a width of 77 inches. Although Chevrolet built the 9C1 on its standard Caprice chassis, it used a thicker, higher-grade steel.

What should the timing be on a Chevy small block motor?

When the rpm is raised to 2500, the mechanical advance takes over and increases the advance to 32 degrees BTDC. The timing is set at 4 degrees initial to allow the engine to turn over much easier when starting. This is easier on the starter. Lift the vehicle’s hood and remove the air cleaner.

Is the Chevy Caprice police car still made?

For years, Chevrolet had the market cornered on police cars, but that changed in 2017. According to GM Authority, the Chevrolet Caprice PPV was discontinued, and it doesn’t appear it’ll be back any time soon. So what happened, and which automaker makes police cars now? Here’s what we found out.

How big is a Corvette LT1 Police Interceptor?

In comparison, the lighter LT1 installed in the Corvette could crank out 300 horsepower and 340 foot-pounds of torque. Chevrolet built the 9C1 on its four-door Caprice sedan. This five-passenger car spanned a length of 214.1 inches with a wheelbase of 115.9 inches. The 9C1 Caprice stood 55.7 inches in height and had a width of 77 inches.

When did Caprice 9C1 police package come out?

In 1999 the Caprice 9C1 name would be revived for the Middle East based on the Holden Caprice from the WH Statesman/Caprice range for the 2000 model year. This same police package was used in the VT Commodore range at the time which was also sold in the Middle Eastern market as the Lumina.

How much horsepower does a Chevy LT1 have?

These cars used Chevy’s 4L60E four-speed automatic transmission to transfer power to the rear wheels. The LT1 installed in the 9C1 Caprice could generate 260 horsepower at 5,000 revolutions per minute (rpm) and 330 foot-pounds of torque at 3,200 rpm. Inside each cylinder, this engine achieved a compression ratio of 10.5:1.

How much horsepower does a Caprice LT1 have?

The LT1 installed in the 9C1 Caprice could generate 260 horsepower at 5,000 revolutions per minute (rpm) and 330 foot-pounds of torque at 3,200 rpm. Inside each cylinder, this engine achieved a compression ratio of 10.5:1. In comparison, the lighter LT1 installed in the Corvette could crank out 300 horsepower and 340 foot-pounds of torque.

What are the dimensions of a Chevy 9C1 Caprice?

Dimensions. Chevrolet built the 9C1 on its four-door Caprice sedan. This five-passenger car spanned a length of 214.1 inches with a wheelbase of 115.9 inches. The 9C1 Caprice stood 55.7 inches in height and had a width of 77 inches.

When did the 9C1 package come out for the Caprice?

In 2012, a 3.6L V6 was introduced as a standard engine, with the 6.0L V8 becoming an option (the first time since 1990 that a V6 was offered in a Caprice). Following the introduction of the WN Caprice for 2014, all PPVs adopted the 9C1 package]

What kind of car was the Chevy Caprice in 1996?

Relatively rare – Chevy built just 638 Caprice wagons in the 1996 model year. This is one of just 44 in medium garnet red, and one of just 8 garnet red wagons with tan interior (most had dark red interior, and a few had grey interior.) Runs and drives great – drive anywhere. You may have noticed I normally list cars at no reserve.

When did the Chevy Caprice 9C1 come out?

Starting in 1986 the Caprice would replace Impala for the retail, taxi, & police markets based on the third generation model which was launched in 1977. Like its civilian counterparts the car would get a facelift in 1987 & would remain the same until 1990. The Caprice 9C1 was available with either a V6 or V8 in this generation.

How old is the 1996 Chevy Caprice Car?

Sometimes, it feels like it was still the ’90s not that long, but it’s been 20 years since they ended. And that means that this 1996 Chevrolet Caprice is now 24 years old! At one time, you saw these fourth-generation Caprices or one of their badge-engineered relatives everywhere.

When did the Chevy Impala replace the Caprice?

Impala/Caprice 9C1 (B-platform) 1996 Chevrolet Caprice 9C1. Starting in 1986 the Caprice would replace Impala for the retail, taxi, & police markets based on the third generation model which was launched in 1977. Like its civilian counterparts the car would get a facelift in 1987 & would remain the same until 1990.

When did the Chevy LT 1 engine come out?

The Chevy LT-1 was released in 1992 as the second generation of small-block General Motors V8s. This version of the LT-1 lasted until 1997, when the LS-1 was introduced. In 1994, the LT-1 was a widely used engine.

What kind of engine does a Buick LT 1 have?

This version of the LT-1 lasted until 1997, when the LS-1 was introduced. In 1994, the LT-1 was a widely used engine. It was used through four manufacturers: Chevrolet, Pontiac, Cadillac and Buick. It was also use in many different types of cars including sports cars, sedans and even station wagons.

What kind of engine does a Chevy Caprice have?

The Caprices had similar-looking 265 c.i.d. small-blocks (L99) that resemble the LT1. These engines are easily identified by their smaller 3.740-inch bores and iron heads. Don’t accidentally pick one of these up for your LT1 build project.

What kind of engine does a 1994 Chevy LT1 have?

This vehicle used GMs 5.7 liter LT-1. This engine produced 260 hp and 330 foot-pounds of torque. It had a compression ratio of 10.5:1. The bore was 4 inches and the piston stroke was 3.48 inches. This vehicle got 17 mpg in the city and 25 mpg on the highway.