Why are the lights not working on my Mercedes?
Why are the lights not working on my Mercedes?
Lights not working – We have seen many Mercedes-Benz where one or a few lights don’t work. It can be that the left or right low beams, fog lights or turn signals may not work. You should always avoid splicing wires to get power for aftermarket HID lights, alarm or connecting a trailer hitch.
When does the Trans overheating warning light come on?
I HAVE A 2006 ISUZU NPR DIESEL WITH A TRANS OVERHEATING WARNING LIGHT THAT COMES ON WHEN THE TRUCK IS FIRST STARTED COLD AND STAYS ON. AM I RIGHT THINKING THAT THE TRANS TEMP SENSOR IS AT FAULT? 55000 … read more
Why are there no Rev lights on my Isuzu NPR?
Ok so looking at the diagram I sent , you have a break between the fuse and that backup switch . You can try and power that switch on one side or the other to see if the lights come on at the rear . This will prove that the circuit from the switch to the lights is good . Are you sure there are no other fuse panels on the truck ?
Where is the 2 wire switch on the Isuzu NPR?
There should be a 2 wire switch up above the tranny . It is threaded into the housing. There should be power there on one side of the switch , and when in reverse, there should be power on both sides. Please have a look and see if that is what is happening !
Why does one side of my LED light not turn on?
If one side sometimes doesn’t turn on it could be caused by a bad bulb, HID ballast, LED driver or wiring. To help identify which component is defective follow these steps. Swap the ignitors to opposing sides (not applicable for LED kits). If the problem is reversed, you might have a bad ignitor.
What are the common mistakes people make when wiring LED lighting?
A common mistake people make when wiring LED lighting products is trying to simplify the installation by jamming 10 wires into a wire nut or phoenix connector.
Why is one side of my HID light not working?
Only one side is working on my HID kit or LED kit. If one side sometimes doesn’t turn on it could be caused by a bad bulb, HID ballast, LED driver or wiring. To help identify which component is defective follow these steps. Swap the ignitors to opposing sides (not applicable for LED kits). If the problem is reversed, you might have a bad ignitor.
Why is the right turn signal light not working?
Back probe the wire that supplies power to the right turn signal lights; the test light should not light. If the test light illuminates, replace the switch. Repeat the test, but this time operate the switch so the right turn signals light.
