How does the AutoLamp work on a Ford Escape?
How does the AutoLamp work on a Ford Escape?
The autolamp system provides light sensitive automatic on-off control of the exterior lights normally controlled by the headlamp control. The autolamp system is factory programmed to keep the lights on for 20 seconds after the ignition switch is turned to off.
How long do the lights stay on in a Ford Escape?
The autolamp system is factory programmed to keep the lights on for 20 seconds after the ignition switch is turned to off. This delay can be programmed, using the procedure listed below, to any value up to 180 seconds.
Where are the fuses on a Ford Escape?
Also, check fuses F4 and F29 in the Smart Junction Box (the fuse panel on the console) and F1 in the Battery Junction Box (under the hood near the battery). The switch part number should be the same for both manual and automatic 2005-2007 models, Motorcraft SW6522 (Ford 8L8Z-15520-A ).
How to set delay time on Ford Escape?
If your vehicle is equipped with autolamps, you can set the delay time to keep the headlights on for up to three minutes after the key is turned off. The delay time is set to 20 seconds at the factory, but the delay time may be changed by following the steps below (Steps 1 through 6 must be done within 10 seconds): 1. Turn the vehicle off. 2.
The autolamp system provides light sensitive automatic on-off control of the exterior lights normally controlled by the headlamp control. The autolamp system is factory programmed to keep the lights on for 20 seconds after the ignition switch is turned to off.
The autolamp system is factory programmed to keep the lights on for 20 seconds after the ignition switch is turned to off. This delay can be programmed, using the procedure listed below, to any value up to 180 seconds.
If your vehicle is equipped with autolamps, you can set the delay time to keep the headlights on for up to three minutes after the key is turned off. The delay time is set to 20 seconds at the factory, but the delay time may be changed by following the steps below (Steps 1 through 6 must be done within 10 seconds): 1. Turn the vehicle off. 2.
How does the dimmer work on a Ford Escape?
• Rotate to full down position (past detent) to prevent interior lamps from illuminating when the doors are opened. Note: If the battery is disconnected, discharged, or a new battery is installed, the dimmer switch requires re-calibration. Rotate the dimmer switch from the full dim position to the full dome/on position to reset.
