How do you install a injector pump?
How do you install a injector pump?
1) Rotate the engine until the #1 piston rises to its highest point. 2) Connect the new pump to all fuel lines, except for the top hard lines that connect to each injector. Do not connect pump yet. 3) Press the primer pump to build pressure, open bleeder valve to release air, then close bleeder valve.
How do you lock a fuel injection pump?
Lock fuel injection pump (3) in this position. In order to lock fuel injection pump (3), loosen locking screw (4) in the fuel injection pump. Slide spacer (5) into Position (YY). Tighten locking screw (4) against the shaft of the fuel injection pump to a torque of 9 N·m (80 lb in). Alignment of timing marks 5.
How do you remove fuel injection pump gear?
Apply sufficient pressure to fuel injection pump gear (2) in a counterclockwise direction in order to remove the backlash. Lock fuel injection pump (3) in this position. In order to lock fuel injection pump (3), loosen locking screw (4) in the fuel injection pump. Slide spacer (5) into Position (YY).
How to remove injection pump from Kubota Fork?
Align the control rack pin (3) with the notch (I) on the crankcase, and remove the injection pump (2). 2. Remove the injection pump shims. 3. In principle, the injection pump should not be disassembled. (When reassembling) When installing the injection pump, insert the control rack pin (3) firmly into the groove of the fork lever and thrust lever.
How to diagnose cranking no start on OM642 diesel?
Use your Autologic early in the process, there is a lot of “free” information you can get with very little time and work. Hook the Autologic up and do a complete vehicle scan, record the scan and do not clear any faults yet. Verify the drive authorization (immobilizer) system is allowing the engine to start.
How to install an injection pump drive nut?
Using SST and a hammer, tap in the timing gear. 09223-00010 (b) Install the injection pump drive gear. (1) Install the set key to the groove of the injection pump drive shaft. (2) The matchmarks on the No.2 balance shaft driven gear should be aligned with “3” marks. (3) Install a new O-ririg gear. (4) Install the injection pump drive gear set nut.
Lock fuel injection pump (3) in this position. In order to lock fuel injection pump (3), loosen locking screw (4) in the fuel injection pump. Slide spacer (5) into Position (YY). Tighten locking screw (4) against the shaft of the fuel injection pump to a torque of 9 N·m (80 lb in). Alignment of timing marks 5.
Where is the timing pin on an injection pump?
Engage the timing pin on the rear of the gear cover into the rear of the camshaft gear. Rotate crankshaft if necessary. Before injection pump installation, it must be set (pump shaft rotated) to a certain position to attain accurate pump timing. Remove the access plug from the side of pump. Injection Pump Timing Pin Tool
Apply sufficient pressure to fuel injection pump gear (2) in a counterclockwise direction in order to remove the backlash. Lock fuel injection pump (3) in this position. In order to lock fuel injection pump (3), loosen locking screw (4) in the fuel injection pump. Slide spacer (5) into Position (YY).
