Can a Hino truck have an ABS fault?
Can a Hino truck have an ABS fault?
Load was once detected or SAE message missing, but was once recieved”. This little truck doesn’t have a drive line retarder, engine brake, exhaust brake, etc. It’s just a 10 tonne cube van. There is no more info in Wabco Toolbox, and no troubleshooting steps. I don’t work on this little stuff, or hydraulic brakes and am a little out of my element.
What does the code say on a Hino truck?
The code says, “Retarder output pin not connected to load. Load was once detected or SAE message missing, but was once recieved”. This little truck doesn’t have a drive line retarder, engine brake, exhaust brake, etc. It’s just a 10 tonne cube van. There is no more info in Wabco Toolbox, and no troubleshooting steps.
How do you erase a Hino fault code?
1. Turn off the ignition. 2. Remove the fuse of the electronic control unit “ECD” or disconnect the wire from the negative terminal of the battery for one minute or more (at low temperature). On models with a DLC3 diagnostic connector, fault codes can be erased with a tester.
How many times does a Hino lamp flash?
For example, the lamp flashes 1 time, then a pause of 1.5 seconds, then flashes 3 times. This means code 13. 7. If two or more fault codes are stored in the memory of the electronic unit, the codes will be separated by a pause of 2.5 seconds. 8. If there are no faults, the test lamp should flash at an interval of 0.26 seconds.
Load was once detected or SAE message missing, but was once recieved”. This little truck doesn’t have a drive line retarder, engine brake, exhaust brake, etc. It’s just a 10 tonne cube van. There is no more info in Wabco Toolbox, and no troubleshooting steps. I don’t work on this little stuff, or hydraulic brakes and am a little out of my element.
The code says, “Retarder output pin not connected to load. Load was once detected or SAE message missing, but was once recieved”. This little truck doesn’t have a drive line retarder, engine brake, exhaust brake, etc. It’s just a 10 tonne cube van. There is no more info in Wabco Toolbox, and no troubleshooting steps.
What is the code for a Hino pressure sensor?
P0117 HM 11 Coolant temperature sensor, the value is below normal. P0118 HM 11 Coolant temperature sensor, a value above normal. P0191 pressure sensor in the common rail, a mechanical problem. P0192 pressure sensor in the common rail, a value lower than the norm. P0193 pressure sensor in the common rail, a value above normal.
What are the five groups of Hino parts?
HINO uses five major groups. Engine – Electrical – Drive – Cab Rear Body and Chassis/Tool The sixth column is the FIGURE #that the part can be found in the Hino Electronic Parts Catalog and is helpful if you need other parts in addition to what’s listed in the Quick Reference Guide. See the example shown above from the EPC.
