Is there a problem with my Hitachi Zaxis 160lc?
Is there a problem with my Hitachi Zaxis 160lc?
I have a problem with my zaxis 160lc, the operator reported that it had ‘clicked’ twice on the starter before starting as normal. It has continued to start normally with no problems, until he noticed two warning lights sticking on when the ignition is turned off.
Why is the starter light not working on my Hitachi Zaxis?
Basically when the alternator was turning there was a voltage on the extra wire which would cause the starter relay to open and not let the starter engage while the engine was running. That same wire also was tied to the monitor panel which turned the light out for engine oil pressure.
What is the service manual for a Hitachi zw220 hydraulic excavator?
HITACHI ZAXIS 850-3 850LC-3 870H-3 870LCH-3 HYDRAULIC EXCAVATOR Service Repair Manual Hitachi ZW220 , ZW250 Wheel Loader (EU Specification) Service Repair Manual Hitachi ZW220 , ZW250 Wheel Loader (Standard Specification) Service Repair Manual
Why is the warning light on in my Hitachi EX 75?
Vocational, Technical or Tra… warning light and alarm coming on in my hitachi ex 75 ur. there is no obvious reason why its coming on. i dont know what the symbol means. Its … read more I have a 35C Deere mini excavator (Hatachi) which has 750 hours on it now.
How many horsepower does a Hitachi Zaxis excavator have?
Catalog excerpts ZAXIS series Southeast Asia HYDRAULIC EXCAVATOR Model Code : ZX120 Engine Rated Power : 65 kW (87 HP) Operating Weight : 12 000 – 12 600 kg Backhoe Bucket : ISO Heaped : 0.45 – 0.50 m3 Open the catalog to page 1 ZX120 is Purpose Built for Harsh Civil Engineering.
Vocational, Technical or Tra… warning light and alarm coming on in my hitachi ex 75 ur. there is no obvious reason why its coming on. i dont know what the symbol means. Its … read more I have a 35C Deere mini excavator (Hatachi) which has 750 hours on it now.
What is the Cres coating on Hitachi zx120?
CRES cab Electrodeposition coating cover The Hitachi ZX120 comes with advanced technologies, including impressive cooling ability to well suppress overheating, and the fuel-efficient non-common rail type engines for productive operations.
HITACHI ZAXIS 850-3 850LC-3 870H-3 870LCH-3 HYDRAULIC EXCAVATOR Service Repair Manual Hitachi ZW220 , ZW250 Wheel Loader (EU Specification) Service Repair Manual Hitachi ZW220 , ZW250 Wheel Loader (Standard Specification) Service Repair Manual
Why does my Hitachi excavator stop on its own?
Be careful that you are not just running on battery power as when she stops next time it could be a right pain if you are in the wrong position. On the older Hitachi excavators there was a diode installed behind the operator’s seat that had to do with the glow plug circuit.
What causes a Hitachi Zaxis to short out?
Basically one of the glow plugs would short out and pull a big current that would burn out the diode. You could find this by checking for burn spots on the glow plug bar. A lot of times this problem would smoke the harness at the back of the engine. The other issue was the alternators had an extra wire that worked a relay on the starter circuit.
Where can I buy replacement parts for my Hitachi?
Looking for Hitachi parts online? you’ll find our extensive inventory of genuine OEM and aftermarket Hitachi replacement parts to be very interesting. Stock includes a wide range of parts to fit your Hitachi equipment from final drive travel to swing devices.
Why does my Hitachi table saw stop running?
Hitachi table saw model C10FL won’t run for more than 1 minute unless I hold the circuit breaker switch. replace motor have motor rewound. The overload is a safety device to prevent motor damage, you may have made things worse by holding reset in. The laser in my Hitachi 10 inch sliding Miter saw stopped working some time ago.
Can a Hitachi c12rsh2 slide back into the box?
Hitachi c12rsh2 new out of the box does not slide back and forth easily. Tried lube, helps some but it should not be this resistant. Any ideas?
Why are the brushes not coming out of my Hitachi saw?
The brushes will not come out, scared to pull on springs to hard. Suggestions please! You might have let the brushes go to long and they are worn so far that they came out of the holders. Maybe try turning the blade backwards while pulling on the brushes.
Why does my Hitachi ZX 1 not throttle up?
There should also be a learning switch to perform engine learning. Basically this makes the stepper motor go to its min and max positions so the controller can remember where low and high idle is. Most Hitachi’s from the ZX-1 and earlier have them.