How to test kubota fuel shut off solenoid?
How to test kubota fuel shut off solenoid?
When you turn the tractor off with the key, you should hear the fuel solenoid kick in, to shut down the fuel flow and the engine , and then a few seconds later, kick back out to allow fuel flow for the next start up. Put a voltmeter on the solenoid wire and see if this voltage shows up when you turn off the key.
How to test a3 wire fuel solenoid?
3 wires, a black wire to ground, red wire goes to positive, white wire touches red wire for one sec to pull and hold the solenoid. When red wire disconnect from positive, it will stop holding.
Why is the solenoid on my Kubota not working?
If the solenoid is getting the correct electrical feeds and is still not working then you have a bad solenoid. The amount of Kubota solenoids for sale on eBay is amazing, so it must be a common problem. If you have gotten the solenoid wet, like from power washing, it is a harbinger for failure.
How to turn off the fuel shut off solenoid?
When i turn off tractor with key it does not activate the fuel shutoff solenoid. I removed wire from solenoid and touched a lead wire right from battery and it works. I put a test light on wire coming from behind dash leading to solenoid and when key is turned off it lights up test light for several seconds as expected.
Why is my solenoid not working on my l3650?
If the solenoid is getting the correct electrical feeds and is still not working then you have a bad solenoid. The amount of Kubota solenoids for sale on eBay is amazing, so it must be a common problem. If you have gotten the solenoid wet, like from power washing, it is a harbinger for failure. I went through three on an L3650 before I wised up.
Why does my Mini plow blade not shut off?
L1501,home built carry all, mini plow blade. My solution in this case ,failing the clean bright and tight rule, would be to add a spdt relay. Then the wire from dash is only a signal to activate relay. Clean/replace your fuses too. Corrosion at fuses can affect this as well. L4610 had corroded fuse and wouldnt shut off tractor.
Where is the fuel shut off solenoid on a Bx23?
As I recall, the fuel shutoff solenoid on the BX23 is normally in the fuel on position with no power applied to it. When shutting down, the timer applies 12 volts to the solenoid for a short period of time to shut down the tractor.
What should I do when I Turn Off the solenoid?
Put a voltmeter on the solenoid wire and see if this voltage shows up when you turn off the key. If not, you may have a timer problem, ignition switch problem, or the wiring in between. Good info from both of you. Got more questions…just got the machine 2 weeks ago. Changing all fluids and filters. Spec’s say engine crankcase with filter 2.6 qts.
What happens if the solenoid on a tractor is not turned off?
The tractor should stop. If it does not, rust or a faulty return spring. If the solenoid was staying energized, your battery would discharge pretty quickly unless you keep the tractor on a maintainer. As I recall, the fuel shutoff solenoid on the BX23 is normally in the fuel on position with no power applied to it.
How many amps do you need to shut off solenoid?
You may also have a key stop relay in circuit which the timer switches to power the shut off solenoid. Solenoid main fuse should be 15~30 amps I expect, and a 5~10 amp on the control circuit. Wiring diagram in WMS indicates 15 amp breaker in line t0 timer.
