Where can I buy a Hurst 4 speed shifter?
Where can I buy a Hurst 4 speed shifter?
ShifterDoc.com has one of the largest selections of replacement parts for Hurst 4 Speed manual shifters and linkage / Install kits., including the Hurst Competition / Plus shifter The Comp Plus has been the benchmark of transmission control since 1965. Many of these parts have been long discontinued by Hurst and are available nowhere else.
What kind of engine did the Dodge 318 have?
The 318 was not just limited to Dodges, but also powered Plymouth and Chrysler cars as well. The engine was remarkably efficient, durable and proved to be Chrysler’s mainstay for many of its vehicles over the decades. Chrysler was known for its superiority in engine technology over Ford and General Motors.
What’s the idle speed on a Dodge 318?
The idle speed was 650 rpm with a manual transmission and 600 rpm with an automatic transmission. Cylinder compression must be relatively uniform among all eight cylinders and within a range of 120 and 160 lbs. In working condition, the fuel pump will provide between 5 and 7 lbs. of pressure to the carburetor.
What was the compression ratio of the Dodge 318?
Ultimately, virtually all Dodge cars were equipped with the optional 318. The 318 had a 3.91-inch bore and 3.312-inch stroke. Its compression ratio in 1968 was a hefty 9.1:1, but was reduced to 8.6:1 by 1973 in the interest of fuel economy.
What kind of engine does a Dodge 318 have?
Dodge first equipped the 318 small-block V-8 in the middle of the 1967 production year. However, the engine was essentially the same as the earlier 273 engine, but with a slightly larger bore. Although the 318 was never considered a high-performance engine, its durability made it a popular engine selection over the base model six-cylinder engines.
The idle speed was 650 rpm with a manual transmission and 600 rpm with an automatic transmission. Cylinder compression must be relatively uniform among all eight cylinders and within a range of 120 and 160 lbs. In working condition, the fuel pump will provide between 5 and 7 lbs. of pressure to the carburetor.
Do you need a tune up for a Dodge 318?
However, the engine was essentially the same as the earlier 273 engine, but with a slightly larger bore. Although the 318 was never considered a high-performance engine, its durability made it a popular engine selection over the base model six-cylinder engines. As with all engines, the 318 does require a periodic tune-up.
What should the ignition timing be on a Dodge 318?
Proper ignition timing was 5 degrees after top dead center if equipped with a manual transmission and 2.5 degrees after top dead center if equipped with an automatic transmission. Note that the distributor’s vacuum hose must the disconnected from the distributor and plugged so that idle speed is not affected.
