Can you replace the speakers in a sprinter?

Can you replace the speakers in a sprinter?

The stock speakers in a Sprinter are cheap and nasty. They sound just about OK with the engine off, but they can’t compete with road noise and have no dynamic range. Here’s how to take them out and replace them. This job doesn’t ask much of you mechanically, other than the ability to lever panels off and strip and crimp connectors on to cables.

Can a check engine light be set off on a sprinter?

If you don’t disconnect the van’s battery before you start work, you could set an airbag off. If you don’t reconnect any loose airbag wires before you reconnect the battery, you can trigger an SRS or Check Engine light. Door panel removal – top screw caps need a thin tool to lever them out.

How do you replace the dash in a sprinter?

Place the crossover in the door space, then pull the tweeter wire through the flexible wire channel between the door and the van body and on through to the dash using a wire fish. Make it easier to thread the wire through by pulling the rubber boot off from the A pillar.

How to remove stereo head unit from sprinter?

Undo the one near the A pillar and the one near the center console and then push the panel away from you (towards the windshield). It will unhook and then you can just lift it clear. One final set of panels you might want to remove is the section under the steering wheel.

The stock speakers in a Sprinter are cheap and nasty. They sound just about OK with the engine off, but they can’t compete with road noise and have no dynamic range. Here’s how to take them out and replace them. This job doesn’t ask much of you mechanically, other than the ability to lever panels off and strip and crimp connectors on to cables.

If you don’t disconnect the van’s battery before you start work, you could set an airbag off. If you don’t reconnect any loose airbag wires before you reconnect the battery, you can trigger an SRS or Check Engine light. Door panel removal – top screw caps need a thin tool to lever them out.

Place the crossover in the door space, then pull the tweeter wire through the flexible wire channel between the door and the van body and on through to the dash using a wire fish. Make it easier to thread the wire through by pulling the rubber boot off from the A pillar.

Undo the one near the A pillar and the one near the center console and then push the panel away from you (towards the windshield). It will unhook and then you can just lift it clear. One final set of panels you might want to remove is the section under the steering wheel.