How do you change the axle on a Dodge Grand Caravan?

Hit the end of the tool with a hammer to separate the knuckle from the control arm. Lift up on the wheel hub assembly and push it to the right while pulling the axle out fo the hub assembly. Pry the other end of the axle out of the transmission with a small flat-tip screwdriver.

How do you reset the computer on a Dodge Grand Caravan?

Press it in firmly to reattach it. Use the adjustable wrench to make sure that the bolt has been tightened until the cable can’t be removed or loosened on the battery post. The bonnet can then be closed and the Dodge Grand Caravan PCM should have been completely reset.

How to replace the brake pads on a Dodge Grand Caravan?

Replacing the rear brake pads and rotors on my 2010 Dodge Grand Caravan. I conducted this repair without the Chrysler Special Tool 8807 used to rotate the caliper piston back into the caliper. This video may not demonstrate proper safety or technique. It is up to you to ensure the safety of yourself and your vehicle. Loading…

How do you replace tailgate light on Dodge Grand Caravan?

Open your tailgate. Look for two (2) round flat black discs about the size of a dime (but thicker) on the inside of the body (between the red lens and the weather striping). Using a pair of pliers, pull out each of these two discs. Note they are in tight and may require a fair bit of force to remove.

Very simple step by step replacement of the brakes on a Dodge Grand Caravan. This is a 2010 SXT but should apply to 2007 & newer model years. In this video I replace the front brake pads and rotors. I am using Autozone Duralast gold ceramic brake pads and standard rotors. Loading…

How do you remove the hub from a caravan?

Remove the hub retaining nut. Remove the tie rod end nuts (if you are working on the front of the Caravan). Remove the lower control arm to the steering knuckle bolt (if you are working on the front of the vehicle). Separate the steering knuckle from the control arm (if you are working on the front of your Caravan).

Do you have to invert the axle on a caravan?

Inverting the caravan axle will lift your annex and perhaps prevent you pegging the sides into the ground. Measure your annex before inverting the axle to avoid surprises. Caravan manufacturers install axles on top of the leaf springs for safety reasons.

How can I raise the suspension height on my caravan?

A good video on what to expect from a caravan expert when flipping the axle to raise the suspension height. The solution to the tyre hitting the mudguard problem is to remove the axle from on top of the leaf springs to a new position, under the leaf springs. Commonly called an underslung axle or axle flip.

Is it safe to put an annex on top of a caravan?

Raising the height of your caravan could prevent your annexe from reaching the ground. Inverting the caravan axle will lift your annex and perhaps prevent you pegging the sides into the ground. Measure your annex before inverting the axle to avoid surprises. Caravan manufacturers install axles on top of the leaf springs for safety reasons.

How does the axle work on a Dodge Grand Caravan?

The axle on a Dodge Grand Caravan transfers power to the wheels from the transmission. The axle’s only weak point is the CV joints on either side of the shaft. These joints provide flexibility in the shaft for normal turning and to absorb vibration from uneven road surfaces. However, the protective boot is prone to failure over time.

Where are the CV axles on a 2003 Dodge Dakota?

This feature is not available right now. Please try again later. The Secret of removing the front CV Axles on a 2003 Dodge Dakota or 1500 series. Also not included in the Video, when you purchase your new axles make sure you check the location of the retaining clip inside of the CV female shaft. They made CV axles with two different locations.

How do you remove an axle from a wheel?

Place the tip of the ball joint separator tool between the control arm and the steering knuckle. Hit the end of the tool with a hammer to separate the knuckle from the control arm. Lift up on the wheel hub assembly and push it to the right while pulling the axle out fo the hub assembly.

How do you change the axle on a Dodge Grand Caravan?