Does Jeep Grand Cherokee have trailer brake controller?
Does Jeep Grand Cherokee have trailer brake controller?
Trailer Brake Controller for a 2015 Jeep Grand Cherokee with Factory 7-Way Connector For your 2015 Jeep Grand Cherokee I recommend the P3 brake controller, #90195. This is a proportional controller that will apply the trailer brakes in proportion to how much the Jeep is braking.
Does a 2017 Jeep Grand Cherokee have a brake controller?
As you can see at the 1:20 mark in the attached video, the factory brake controller harness on your 2017 Jeep Cherokee will be located under the driver’s side dash panel. The connector will be grey in color and positioned just to the left of where the brake pedal mounts to the firewall.
How does a Bluetooth brake controller work?
A Bluetooth brake controller is a brake controller that uses radio signals to connect to your smartphone, allowing it to become the interface for trailer brake operation. Bluetooth eliminates the need for physical wires or cables to be connected from the brake controller to the phone.
What kind of brake controller do I need for my Jeep Grand Cherokee?
Today on our 2015 Jeep Grand Cherokee we’ll be installing the Tekonsha Prodigy P2 Trailer Brake Controller, part number 90885. We will also be using the Tekonsha Plug In Wiring Adapter for Electric Brake Controllers part number 3045-P.
What kind of wiring does a jeep GC have?
The GC also came with “Electric Brake Kit PN 68320483AA REV:A” found in the glove compartment. This kit is a wiring harness to ease the install of a brake controller. Using this kit, I installed an aftermarket brake controller.
Do you have to install a brake harness on a jeep?
Does Jeep have the electric trailer brake wiring harness pre-installed or did you have to install that too? April, check out the below thread. What JGC and trailer/brakes do you have? If you have the V8 with Tow Package IV, which includes 7 pin and 4 pin plugs, you’ll only need to add a brake controller.
How does a trailer brake controller work on a jeep?
What you do, you’ll get a C4 00:00:33 connection, go ahead and run through the functions. Here’s the manual override here on the bottom of it. You can see it’s getting power. The button right here on top, that adjusts the boost on your brake controller. That changes how aggressive your brakes come on, on your trailer.
Where is the trailer brake controller on a Jeep Grand Cherokee?
I would need to install a trailer brake controller. On the Grand Cherokee, I know there is a small port (not the OBDII port) under the dash (driver’s side footwell) where a trailer brake controller would plug into to avoid having to cut wires. Can anyone confirm that this port exists on the Cherokee?
How to install a P2 brake controller on a Jeep Grand?
The first step in installing our Prodigy P2 Brake Controller, there’s a felt lining under here, underneath the dash. It has two push pin fasteners. You pull it to get them loose or if you have a trim panel removal tool you can go ahead and work that in there, pop that free. Go over here on this side, pop that one down also.
Where is the plug for the trailer brake controller?
It is located behind the plastic kick panel in the drivers foot well. You remove the screw and carefully pry the tab that is holding the kick panel in place from its bracket. The plug is on the firewall/wheel well behind the wiring. It is the grey plug you can see next to the metal bracket.
Where are the connectors for the Mopar trailer brake module?
Disclosure (s): Before ordering the Mopar Integrated Trailer Brake Module (ITBM) kit, it is necessary to check if the vehicle has both trailer brake module connectors. These connectors are located under left side of the steering column. Both connectors are 4 pin connectors.
