Is it easy to change rear axle seal on Chevy Silverado?
Is it easy to change rear axle seal on Chevy Silverado?
You may be tempted to take it to the dealer to get this done, but if you have a good set of tools, a bit of patience, and this guide, you will be able to do this job yourself and save some money. As there are a few points to follow, we’re going to break it down into easy-to-follow sections for each major job.
How do you remove a rear axle seal?
You have to open the differential, remove the lock pin and the axle retaining clip, then you have to pull the axle out which may require removing the rear caliper and rotor if you have disc brakes, or the drum if you have drum brakes. Then you can remove the old axle seal.
How do you install a new rear axle?
You have to open the differential, remove the lock pin and the axle retaining clip, then you have to pull the axle out which may require removing the rear caliper and rotor if you have disc brakes, or the drum if you have drum brakes. Then you can remove the old axle seal. Be sure to inspect the mounting area before you install the new one.
How do you remove a retainer from an axle?
Pull the pin out and you’ll see the axle retainer clip. It’s a C shape. Pull the clip out (you’ll need to push the axle in a little to get it out). Then you can pull the whole axle shaft out. Your seal will be in the end of the axle tube. Pop that out being careful not to damage the bearing.
You have to open the differential, remove the lock pin and the axle retaining clip, then you have to pull the axle out which may require removing the rear caliper and rotor if you have disc brakes, or the drum if you have drum brakes. Then you can remove the old axle seal.
You have to open the differential, remove the lock pin and the axle retaining clip, then you have to pull the axle out which may require removing the rear caliper and rotor if you have disc brakes, or the drum if you have drum brakes. Then you can remove the old axle seal. Be sure to inspect the mounting area before you install the new one.
Where is the rear axle seal on a GMC Sierra?
Pull the pin out and you’ll see the axle retainer clip. It’s a C shape. Pull the clip out (you’ll need to push the axle in a little to get it out). Then you can pull the whole axle shaft out. Your seal will be in the end of the axle tube.
Pull the pin out and you’ll see the axle retainer clip. It’s a C shape. Pull the clip out (you’ll need to push the axle in a little to get it out). Then you can pull the whole axle shaft out. Your seal will be in the end of the axle tube. Pop that out being careful not to damage the bearing.
