Easy lifehacks

Are there any fuses that are still working?

Are there any fuses that are still working?

All of the fuses were still functional (non blown). 85 which is for “electronic 15 feed” looked a little corroded so i took a brush to the fuse, cleaned it then popped it back in. Started the car and the dash lights up, and everything works fine now. im not sure what the electronic 15 feed is for but that was the only dirty looking fuse.

Why is my radio and dashboard not working?

There is one for 2015. but that’s because part of the instrument panel wasn’t working due to a software update. not the whole thing. my entire cluster was dead. Newer cars more problems. :/ THANKS FOR YOUR INPUT! I ended up going through the fuse list, and singled out 5 that could’ve possibly been the culprits.

Why is my Ford Escape radio not working?

I haven’t heard about this recall on the 2013 ford escapes. There is one for 2015. but that’s because part of the instrument panel wasn’t working due to a software update. not the whole thing. my entire cluster was dead. Newer cars more problems. :/

What to do if your car radio is not working?

You never touch the battery, don’t even remove its cover. Don’t let the removed negative battery lead touch anything metal when you pull it off. That breaks the battery circuit completely and removes all battery current to all system in the car. Leave it off a few (15 +/-) minutes to let everything discharge/reset.

What causes dash lights to fail after installing stereo?

If it is grounding out it would cause the dash lights to fail. Disconnect all orange wires and report back. So i went and dug thru my new hu box and i remember they put a wire diagram in there for me. On mine it says that the Orange/Black isnt used. Ill add a picture to this once it uploads onto photobucket. Biscuits likes this.

Why are the radio lights flickering on my 2005 Jeep?

2005 LJ – Similar problem. Factory Radio would “pop“ and turn off then dash lights and radio lights would flicker. Happened over and over again. After reading this thread popped hood. Checked battery with multimeter and it was good. Started engine and alternator charge function was good.

Are there any flickering lights on the odometer?

The only lights flickering were the odo, trip, and radio from what i seen while it lasted (maybe 10 sec) and it stopped. I turned the car off waited a few started it back up, turned on every acc possible and it was fine. I checked the battery, alt, all the fuses and relays and reset the pcm and everything has the right voltage and looks normal.

All of the fuses were still functional (non blown). 85 which is for “electronic 15 feed” looked a little corroded so i took a brush to the fuse, cleaned it then popped it back in. Started the car and the dash lights up, and everything works fine now. im not sure what the electronic 15 feed is for but that was the only dirty looking fuse.

Where do I find the fuses for my MMI?

If your MMI doesn’t start up at all, then it’s probably not receiving power. The fuses that control many of the MMI modules are located in a compartment in the left side of your trunk. Pry open the side panel in the trunk and inspect the fuses.

Where is the fuse block located on a suburban?

The instrument panel fuse block access door is located on the driver’s side edge of the instrument panel. The center instrument panel fuse block is located underneath the instrument panel, to the left of the steering column. The underhood fuse block is located in the engine compartment, on the driver’s side of the vehicle.

Why are my MMI control buttons not working?

With the MMI control buttons all checked over but still experiencing problems, keep going. If none of the other modules are at fault, then there’s only one other possibility. If your main MMI module has stopped working, then it will be costly to replace it.

Is there a fuse for the instrument panel cluster?

GM Tech (Cam) : Ok then it is not a fuse but is the instrument panel cluster (IPC) assembly. GM Tech (Cam) : YOu will need to send it out for repair. www.gmcluster.com is one I would look at. Customer: Thanks, XXXXX XXXXX it in for repair GM Tech (Cam) : IS there more I can get for you? GM Tech (Cam) :

Why is the touch screen on my LCI not working?

Small red lights are on. None of the buttons work. Received new touch pad but no difference. The blank screen on your LCI Ground Control 3.0 could be either a power issue or a control module issue.

What kind of fuses does a Ford F8 have?

THANKS FOR YOUR INPUT! I ended up going through the fuse list, and singled out 5 that could’ve possibly been the culprits. I pulled and checked F8, F22, 69, 79, 85.

Author Image
Ruth Doyle