Why does my Dodge Ram make grinding noises?
Why does my Dodge Ram make grinding noises?
JUST HAD LOWER AND UPPER BALL JOINTS REPLACED. CHECKED REAR AXLE FLUID, IT WAS LOW, SO I BOUGHT 75-140W GEAR OIL WITH LIMITED SLIP ADDITIVE MADE INTO IT. FILLED AXLE AND WHEN TRUCK WARMED UP UNDER NORMAL OPERATING TEMP, EVERY TIME STARTED OFF FROM DEAD STOP AND MAKING TURNS, TRUCK REAR AXLE MADE VERY BAD GRINDING NOISES.
Why does my Dodge Ram make a cricket noise?
The dealer did tell me that dodge chrysler has a bullitan that says cricket noise is coming from the speaker when sterio turned down low or off is interference from GSM type cell phones to close to radio or amp I have a 2003 dodge 3/4 ton 2 wl drive cummins. At 60 to 75 mph I get this fairly loud low pitch whining noise.
When does the grinding noise start in a car?
When decellerating from about 10 to 15 mph, the noise starts. It’s a cyclic noise that is porportional to the speed of the car. It’s not related to the engine speed or transmission speed (clutch can be in, or trans in neutral). Another important fact is that the noise does not happen when the car is cold.
Where does the rattling noise come from in a truck?
On the way home I stopped at a traffic light and noticed an unusual “dull sounding rattling” noise coming from the firewall/floor/engine area. The noise only happens at idle speed, as soon as you touch the accelerator it goes away completely.
What’s the grinding noise coming from the front of my Dodge Ram?
2012 Dodge RAM 1500 55k miles. About 2 weeks ago I noticed a grinding/rubbing sound coming from the front drivers side. I inspected the breaks and they were worn and needed replaced.
What makes a grinding noise in the front of a truck?
Did they change the calipers? it might be sticking, causing you to hear a noise. The brake dragging or the new parts could be causing the smell. I have seen stuck calipers cause a truck to pull left or right and or buck front to back.
Why does my transfer case make a grinding noise?
Transfer Case grinding noise – FIXED! Discussion in ‘ Mechanic’s Corner ‘ started by stadt11, May 23, 2010 . My transfer case has started making a horrible grinding noise. First I thought it was coming from the driveshaft or the front/rear diff, but wasn’t sure.
Why does my oil pump make grinding noise?
Oil pump wear clip P/N 12470559 is broken or out of position. This may cause the pump to wear a pin hole in the transfer case rear half. If the wear is severe the transfer case may be damaged due to lack of lubrication. The clip may fatigue and break.
What causes exhaust leak on Dodge Hemi 345?
Broken manifold bolts on the HEMI 345 create an exhaust leak. If it’s bad enough then you may notice power loss. A lot seem to fail even under the warranty period, so initial failures should be fixed by the dealership at no cost. Otherwise, you may be on your own for the repair.
Why does my Dodge Hemi engine keep ticking?
This seems to be the most common and serious cause of the Chrysler 345 HEMI engine ticking problem. It also appears most common on 2009+ models leading some to believe the multi-displacement system is to blame. It does make sense.
Are there any problems with the Dodge Hemi engine?
Also, engines are subject to potential problems that we won’t cover. Earlier HEMI engines are getting old and a lot of problems become fair game on old, high mileage engines. That said, let’s move onto the problems we outlined above. Spoiler – this can sometimes tie into the other common problems.
