How do you reset the computer on a 2001 Dodge Ram 2500 Diesel?

To reset the “Perform Service” indicator system (after performing the scheduled maintenance) refer to the following procedure:

1. Turn the ignition switch to the ON position (Do not start engine).
2. Press and release the brake pedal two times.
3. Fully depress the accelerator pedal slowly two times within 10 seconds.

How do you reset the computer on a Dodge Ram 2500?

How to Reset a Dodge Ram Computer

1. Unlatch the hood by pulling the hood release handle near the driver’s side foot well. Depress the handle underneath the Ram’s grille and open the hood.
2. Disconnect the negative terminal cable from the battery with a combination wrench.

Where is the engine control module located on a Dodge Ram?

2001 Dodge Ram 1500 SLT – The engine control module or, in this case, the powertrain control module (PCM) is located in the engine compartment, on right side of firewall. Jeep Wrangler – Depending on the year of your Jeep Wrangler, the engine control module should either be located below the hood or under the dashboard.

Where is the ECM located on a Dodge Ram?

To help you out, here are some examples of where the ECM is located on a few different makes and models: 2001 Dodge Ram 1500 SLT – The engine control module or, in this case, the powertrain control module (PCM) is located in the engine compartment, on right side of firewall.

Where is the Transmission Control Module located on a dodgetalk?

Not open for further replies. Well a week after the dealer the delay shifting is back, but only on wet humid days and it is definately an electrical issue. I would like to know where the Transmission Control Module is located. Is it under the dash or part of the ECM module under the hood.

What is the name of the engine control module?

The engine control module (ECM) is also known as the powertrain control module (PCM) or the engine control unit (ECU).

Not open for further replies. Well a week after the dealer the delay shifting is back, but only on wet humid days and it is definately an electrical issue. I would like to know where the Transmission Control Module is located. Is it under the dash or part of the ECM module under the hood.

Where to find the TCM module in a Dodge truck?

While that is pretty nice when it comes to looking for wires, i’m actually looking for a diagram that shows the cab of the vehicle (or a close up of a certain section) that shows the wiring harness as a whole going from PCM to various spots on the transmission.

How to replace a 2001 Dodge Ram ECM ECU?

It is critical not to skip this step so the CM can learn the accelerator pedal position’s sensor calibration. If this step is skipped, diagnostic codes may be displayed. 8-Use a scan tool to erase previous diagnostic codes from the PCM. We have a huge selection of 2001 Dodge RAM Pickup PCMs.

Where are the fuse panels on a Dodge Ram?

Here you will find fuse box diagrams of Dodge Ram Pickup 1500/2500/3500 1994, 1995, 1996, 1997, 1998, 1999, 2000 and 2001, get information about the location of the fuse panels inside the car, and learn about the assignment of each fuse (fuse layout) and relay.

How do you reset the computer on a 2001 Dodge Ram 2500 diesel?

To reset the “Perform Service” indicator system (after performing the scheduled maintenance) refer to the following procedure:

1. Turn the ignition switch to the ON position (Do not start engine).
2. Press and release the brake pedal two times.
3. Fully depress the accelerator pedal slowly two times within 10 seconds.

What was the mileage on a 2001 Dodge Ram?

2001 Dodge Ram 2500 injection and transfer pump was replaced. At the time of repair the technician did not install the retrofit transfer pump, instead he put in a cheaper pump. At the time the mileage was 47810.

What was the fuel pressure on a 2001 Dodge Ram?

2001 Dodge Ram 2500 injection and transfer pump was replaced. At the time of repair the technician did not install the retrofit transfer pump, instead he put in a cheaper pump. At the time the mileage was 47810. A little over a year later the led light for the fuel pressure illuminated. The transfer pump had failed again.

Where did my 2001 Dodge Ram die on the freeway?

2001 Dodge diesel lift pump failures. Mine has died twice driving on the freeway. 55,000 miles on my truck. The second one left me in the # 2 lane of the 405 freeway in so. Calif.

Where did the Dodge Ram 2500 come from?

1st owner purchased on 05/16/01 and owned in MN until 04/10/06 • 2nd owner purchased on 04/10/06 and owned in MN until 08/13/14 • 3rd owner purchased on 03/12/15 and owned in CO until .

Can a Dodge Ram 2500 be used for underground mining?

The Dodge Ram Pickup 2500 not only can move mountains, it can go through them. The entire Ram pickup class is the only pickup certified to be used as underground mining transport, with a modified version of its diesel engine. That is one tough truck.

Where was the Dodge Ram 2500 last serviced?

Last serviced in Salem, OR on 04/17/18 • Vehicle serviced • Tire (s) replaced. Mileage: 186,691 miles Body Type: Pickup Color: White Engine: 6 Cyl 5.9 L Accident reported: minor damage. Purchased on 08/10/01 and owned in NV until 04/07/21. Driven an estimated 10,056 miles/year. Last serviced in Reno, NV on 08/14/20 • Vehicle serviced.

How many miles does a Dodge Ram 2500 have?

Mileage: 116,864 miles Body Type: Pickup Color: Red Engine: 6 Cyl 5.9 L No accident or damage reported to CARFAX. 1st owner purchased on 06/05/00 and owned in IA until 07/25/02 • 2nd owner purchased on 07/25/02 and owned in IA until .