How do you replace the valve cover on a Toyota Camry?
How do you replace the valve cover on a Toyota Camry?
Slip the new valve cover gasket into the grooved section of the valve cover, and ensure that it is seated flush with the surface. If the valve cover is reinstalled with the gasket not seated correctly, it could tear the gasket and ruin it.
How big is the valve cover gasket on a Toyota?
Click to expand… 52 in-lbs from Toyota. I bought the parts from Toyota and the spark plug tube seals (11193-15010) were separate, as were the little circular gaskets under the valve cover bolts (90210-06010). Mine came off easy with no prying.
Where is the PCV plug on a Toyota Camry?
Pull the plug wires off by hand. The PCV valve, located in the center of the valve cover, should twist and pop out. These tend to be fragile after many miles of service, so be as gentle as possible. The vacuum hose on the driver’s side of the motor has a clamp on it, so get out your pliers and slip it off; the hose should then come free.
How to tighten valve cover gasket torque settings?
52 inch-lbs, thats straight from the chiltons manual and as stated above tighten them down diagonally. i used black magic engine shine to degrease my cover, it works great EDIT: While I’m thinking about it, these things don’t get stuck do they?
How much torque does a Toyota Camry valve cover have?
According to the Chilton repair manual for 1997-01 Camry, the torque for “Spark plug tube nuts” is 33 Ft-lbs. I believe the previous generation of Camry (3rd) used to be recommended at 17 ft-lbs. It’s been updated to 33 ft-lbs for all 5S-FE engines. 17 is way too low.
How do you clean the valve cover on a Toyota Camry?
Do the same on top of the valve cover that fits over the spark plug well. Use a bit of brake cleaner and some Q-tips (if you’re gentle, resume the use of the razor blade) and clean the mating surface of the valve cover to ensure a leak-free gasket install. Figure 9. Cleaning the valve cover groove. Figure 10. Cleaning the valve cover’s groove.
Click to expand… 52 in-lbs from Toyota. I bought the parts from Toyota and the spark plug tube seals (11193-15010) were separate, as were the little circular gaskets under the valve cover bolts (90210-06010). Mine came off easy with no prying.
Pull the plug wires off by hand. The PCV valve, located in the center of the valve cover, should twist and pop out. These tend to be fragile after many miles of service, so be as gentle as possible. The vacuum hose on the driver’s side of the motor has a clamp on it, so get out your pliers and slip it off; the hose should then come free.
