How should I ground my amp?
How should I ground my amp?
First, scout out an ideal location for your grounding point that is within 18” of the amplifier itself (the shorter the length or distance the better). For the most solid connection, it is highly recommended to attach the ground wire with screws or metal nuts directly to the metal chassis of your vehicle.
Will car amp work if not grounded?
a bad ground (or no ground) would prevent an amplifier from turning on. not connecting a 12v+ remote turn on wire, would too, prevent an amplifier from turning on. a blown fuse from a spark will prevent an amplifier from turning on. just a personal note: take off the ground (from the battery) first before installation.
Where do you connect speakers to a Taurus?
In the case of the Taurus, the adapter includes 20′ of speaker wire to reach the trunk. A vehicle’s stereo system sometimes has a separate amplifier, and when installing a new receiver, you generally need to connect the new stereo’s speaker wires to the factory amp’s output section.
Where is the turn on wire on a car amplifier?
The turn-on wire (also called the remote wire) is located behind the stereo. On aftermarket stereos, it’s usually a blue and white wire. The remote wire will “tell” your amplifier to turn on whenever the stereo is powered up (usually, whenever the vehicle is turned on). You’ll have to remove the stereo to get to this wire.
How big of a ground wire do you need for a car audio amp?
It should be less than two feet in length and tightly attached to a good ground somewhere on the chassis. If it isn’t, you can try installing a ground wire of the proper length and attach it to a known good ground. If that doesn’t fix the problem, or the ground was good, to begin with, the amp itself may be faulty.
How to properly ground an automotive electrical system?
A basic ground system is as follows: Always use a heavy ground cable and connect one end to the negative battery terminal, and the other end to the starter motor or engine block as close to the starter as possible. This will insure the correct ground path to the starter motor.
What kind of stereo harness does a 1997 Ford Taurus use?
Ford Taurus 1997, Aftermarket Radio Wiring Harness by Metra®, with OEM Plug and Antenna Extension. For aftermarket stereo. Metra preassembled wiring harnesses can make your car stereo installation seamless, or at least a lot simpler…. Ford Taurus 1997, Wiring Harness with Amplifier Bypass Plug by Metra®.
In the case of the Taurus, the adapter includes 20′ of speaker wire to reach the trunk. A vehicle’s stereo system sometimes has a separate amplifier, and when installing a new receiver, you generally need to connect the new stereo’s speaker wires to the factory amp’s output section.
The turn-on wire (also called the remote wire) is located behind the stereo. On aftermarket stereos, it’s usually a blue and white wire. The remote wire will “tell” your amplifier to turn on whenever the stereo is powered up (usually, whenever the vehicle is turned on). You’ll have to remove the stereo to get to this wire.
What kind of amplifier do I need for my car?
Given my background, they put me to work writing about some of the most complex electronic products Crutchfield sells: car amplifiers, digital signal processors, wiring, professional sound mixers, and PA systems. Q: How do I install an amplifier?
