Do torque multipliers require calibration? The torque multiplier shall be re-calibrated if it was exposed to an overload larger than 20% of the rated capacity, after a repair has been carried out or after an improper use which can influence the measurement uncertainty and/or the multiplication ratio. Do old torque wrenches need to be calibrated? Torque wrenches need to be taken care of properly and periodically calibrated. This may not be as good as sending it to a professional, but it is a good practice in between certifications and better than not doing any calibration. How much does it cost...

What do the numbers on the injector lines mean? Treat each injector line port as a time on the clock. Since there are only 8 injector lines, then not every hour on the clock will be utilized. On top of the intake manifold are numbers by each glowplug. These number represent the cylinder identification. The number closest to the injector denotes the number for the injector line. What is the injector line order for a 6.9 Idi pump? This article contains the injector line order for a 6.9 or 7.3 IDI injector pump. This is important information if you have...

Why do I keep losing power? Causes. Generally, the power goes out for two reasons; a circuit breaker or fuse is tripped in your home, or the power lines themselves are affected. If the power has gone out just in your house, or some items are working but some aren't, it's a sign that the cause is somewhere in your electrical system. What does losing power mean? A power outage (also called a powercut, a power out, a power blackout, a power failure, a power loss, or a blackout) is the loss of the electrical power network supply to an...

What does an electronic control module do? An electronic control unit (ECU), also known as an electronic control module (ECM), is an embedded system in automotive electronics that controls one or more of the electrical systems or subsystems in a vehicle. How do I install an electronic control module? Unbolt the screws holding the ECM in place (Tool: Socket Wrench)Pull the old ECM out and replace it with the new one.Bolt the new ECM in place. Reconnect the electrical wires and the battery.Start your vehicle to verify all the functions are working.Check engine light is off.Car revs up smoothly. What...