Easy tips

Where do you put the FOBS on a corvette?

Where do you put the FOBS on a corvette? PLACE the first key fob into the glove box slot with the key ring facing outwards and the buttons facing the passenger side of the vehicle. After 3 to 4 seconds, the DIC will beep and read “Ready for Fob #2”. REMOVE the first key fob from the slot and PLACE the second key fob into the slot. The car can program a maximum of four key fobs. Why does my Corvette say no key fobs detected? Prompted by a question from a 2006 Corvette owner, the business site addresses an...
Other

How many miles does a 2005 Chevy Impala drive?

How many miles does a 2005 Chevy Impala drive? 1st owner drove an estimated 0 miles/year • 2nd owner drove an estimated 0 miles/year • 3rd owner drove an estimated 8,855 miles/year • 4th owner drove an estimated 1,433 miles/year • 5th owner drove an estimated 0 miles/year. Who is the owner of the 2005 Chevy Impala? 1st owner purchased on 04/28/05 and owned in MN until 11/02/05 • 2nd owner purchased on 12/29/05 and owned in MN until 09/05/07 • 3rd owner purchased on 06/23/08 and owned in MN until . When was the last time I owned a...
Other

What kind of 4 wheel drive does not engage?

What kind of 4 wheel drive does not engage? My 2003 3/4 ton Silverado won't engage in 4 high. The light will come on and then goes back out,it goes in 4 low OK but won't stay in 4 high. It's a 6.0 with a shift lever for the 4 wheel drive. My email is [email protected] if anyone has an answer! Why does my Chevy 2500 not have 4 wheel drive? Front axle is not engaging 4 wheel drive, replaced actuator and can hear it working but still no 4 wheel drive For what it's worth my 2000 chevy 2500...
Most popular

Can a fuel leak cause a Chevy Suburban to stop running?

Can a fuel leak cause a Chevy Suburban to stop running? While P0455 is not going to cause the Suburban’s engine to stop running, it should not be treated lightly. You could have a fuel leak. Pay extra attention to your tank level and make sure you are not leaking fuel. We recommend taking it in and/or dealing with it right away. How does the EVAP system work in a Chevy Suburban? System Gross Leak Evaporative Emission System The EVAP system captures all fuel vapor from the fuel tank and sends them to the engines intake in order to be...
Most popular

Can you replace upholstery on a Chevy S10?

Can you replace upholstery on a Chevy S10? Chevrolet S10 upholstery replacements for your truck will give your vehicle interior a new and fresh update. Each of our Chevrolet S10 upholstery sets is manufactured to original pattern specifications and we offer a choice of fabric colors. Our Chevrolet S10 upholstery will instantly renew your vehicle to show room condition. Is there an amp in the back of my Blazer? Well, just before this starting happening, my son and I installed a sub and amp in the back of the Blazer. Is there a problem with my Chevy Blazer 4x4? Yes...
Most popular

What is the cost for an engine swap?

What is the cost for an engine swap? We'll get into the specifics of price in a bit, but at a minimum, you should expect to pay at least $3,000 dollars for an engine swap if you're paying a mechanic to get it done. If you're doing it yourself? You might not pay as much in cash, but you sure will pay in labor. How much labor does it take to replace an engine? You should expect between 15 to 25 hours of labor for an average engine replacement on a new vehicle. A big part of that will come...
Easy tips

Why does my car temperature gauge read Cold?

Why does my car temperature gauge read Cold? If it reads ~30-50 Ohms or even s/c (short circuit) when cold then the sensor is faulty. You can also check that there is no visible connection between the brass body of the sensor and its' silver connector tag, due to a manufacturing defect From your picture there is an insulator (brown ring) there. Use a magnifying glass if you want to. What should the temperature gauge be on a hot engine? With a hot engine it should measure 30-50 Ohms. If you measure around this value (or definitely not near 140...
Easy tips

How do I program my DSC alarm remote?

How do I program my DSC alarm remote? System programming is entered by pressing * 8 then the installer code. The factory installer code is 5555. The keypad will chirp five times and the armed led will light to indicate the system is waiting for you to enter the three digit programming section you want to program. Can you program any remote to a car? You could reprogram a key fob to a different vehicle as long as the key is the same for the vehicle. Put the key in the ignition and turn the key to the 'ON' position....
Easy lifehacks

What kind of window latch does a Silverado ext have?

What kind of window latch does a Silverado ext have? Glorious little piece of plastic! 3 years ago the rear driver side window of my Silverado Ext Cab truck mysteriously shattered into a million pieces while I was dropping a friend off at the airport. Had it replaced through my insurance. Never fit correctly again.... How long does it take to change window latch? Took about 1 minute to remove the old pieces and pop the new latch into place. Didn't even need any tools. Works perfectly! And behold, the blasted window no longer pops open when I shut the...
Easy lifehacks

Why do people back their trucks into parking spaces?

Why do people back their trucks into parking spaces? Generally, there's no traffic in a parking spot, and backing up has less visibility than pulling forward. So if you have a space that you must either back into or out of, it's safer to back into the space to park than to back into traffic to leave. What's the best way to back into a space? The next step in our “ how to back into a parking space ” guide is moving the bumper and alerting others. After successfully grabbing the spot, it’s time for the real showcase that...