Other

What temperature should a diesel engine run at?

What temperature should a diesel engine run at? With a new 88C stat, diesels seem to run around 88-92C, but rarely higher. In stationary traffic all engines will heat up, diesels included. The petrol engines also use an 88C thermostat, but typically run at 95-100C, eflecting their lower efficiency maybe, but they are also lighter and made from aluminium. What happens if you don't let the Turbo Cool Down? This will cause damage to the blades inside the turbo and eventually wear down the turbo until it breaks. Not Letting the Turbo Cool Down. After a long drive or aggressive...
Common questions

Can you roll start a Cummins?

Can you roll start a Cummins? Yes, you can roll start these trucks. What kind of transmission does a Dodge Ram have? Additionally, Dodge introduced a new overdrive automatic transmission for reduced fuel consumption. This light-duty transmission was designated the A500, and was offered with the 3.9 L V6 and 5.2 L V8. An "O/D Off" pushbutton switch to lock out the overdrive 4th gear was added to the message center. When did Dodge start using Cummins diesel engines? The Cummins diesel was in short supply the first two years, but for 1991 Dodge managed to ramp up production. Partway...
Easy lifehacks

What does an idler pulley do on a car?

What does an idler pulley do on a car? An idler pulley is a specific part of a vehicle’s belt system that helps regulate how the belts run from the crankshaft to generate movement in other parts and engine accessories. It is one of a set of pulleys that a belt rests on. Why does my idler pulley squeal when I Turn on the engine? Another common symptom of a possible issue with the idler pulley is squealing from the engine belts. If the surface of the idler pulley wears, or the pulley seizes or binds it may cause the...
Easy tips

When to Change headlight bulbs on Dodge Ram 1500?

When to Change headlight bulbs on Dodge Ram 1500? Headlights grow dimmer by up to 20% over time and eventually burn out - for this reason, we recommend changing your headlights in pairs. Changing both headlight bulbs on your Ram 1500 at the same time will allow both bulbs to have the same intensity and prevent the new headlight bulb from appearing brighter than the bulb on the opposite side. What kind of head lights do I need for a 2010 Dodge Ram? Dodge Ram 2010, G10 LED Headlight Conversion Kit by Lumen®. 1 Pair, 6500K, 4000lm (per kit). Upgrade...
Easy tips

What do you need to install an alternator?

What do you need to install an alternator? The only other cable running to the alternator connects to a harness, so it will be easy to identify. Set the bolt aside someplace safe until you install the new alternator. Release the safety clip connecting the wiring harness. The only other wiring heading into the alternator is the control harness. Do you need to remove serpentine belt to change alternator? As you loosen the bolts, the alternator will slide in the bracket under the tension of the belt. You may not need to remove the serpentine or accessory belt if it’s...
Common questions

Why is my turn signal out on my Dodge Ram?

Why is my turn signal out on my Dodge Ram? Turbo, Baby! The loss of individual LED bulbs is read as a below acceptable threshold low voltage draw by the Canbus system and therefore it reports a failed turn signal. The tiny LED's can be replaced. How to troubleshoot a burnt out turn signal bulb? Troubleshooting for burnt out turn signal bulbs in your 1500 is relatively easy - turn your hazard lights on and check the front of your 1500 and then the back, whichever side is not illuminating is the side with the burnt out bulb. Can a...
Easy lifehacks

What kind of noise does a truck make when it goes over bumps?

What kind of noise does a truck make when it goes over bumps? When the rear of my truck goes over bumps it makes a rattle/clunking noise but I can’t find where it is coming from. Here is a video of the noise. http://youtu.be/VoiY60ZDjgQ Why does my car make a clunking noise when I drive over a bump? Cars that make clunking noises as they drive over bumps may have worn struts or leaf spring shackles, or damaged control arms or shock absorbers. If you drive over bumps and hear a clunking sound, there is a good possibility that something...
Other

How does an inboard water pump impeller work?

How does an inboard water pump impeller work? The entire job is about $100 of cheap insurance. The torn-up blades of this inboard impeller are not going to move much water. The impeller itself is simply a series of rubber vanes molded around a hub. The vanes are flexible, and the hub rotates on an eccentric within the pump housing, which has a stainless steel liner. What can cause a water pump impeller to be ruined? A ruined impeller can also be caused by running aground, says David Greenwood, product planning manager at Suzuki Marine. “You can suck a lot...
Easy lifehacks

Is the heater core located?

Is the heater core located? The purpose of your heater core is to disperse heat and let your heater and defroster function well. The heater core is usually located right behind your car's dashboard and is usually a tricky place to get to. Can a car heater core leak into the cabin? Even if you have an older vehicle with the heater core outside the cabin, leaking fluid can still find its way into the cabin through the ventilation ducts. Having coolant leaking into the cabin of your vehicle can cause all sorts of problems. Can you replace the heater...
Easy lifehacks

How to repair Mercedes Sprinter DEF tank heater?

How to repair Mercedes Sprinter DEF tank heater? If the tank in your vehicle is mounted in the engine compartment (MB option KP2) then please choose the repair kit for vans with the KP2 option by selecting it from the options above. This product is backed by a manufacturer’s warranty. View XeMODeX’s warranty policy and how to submit a claim here: https://xemodex.com/us/warranty-return-policy/ Why is my recirculated heater not working in my sprinter? NOTE: It has been known that a failure of the recirculation flap actuator valve (venting to atmosphere) or leaking supply pipework has lead to turbo boost control issues....