What do you need to install an alternator?
What do you need to install an alternator?
The only other cable running to the alternator connects to a harness, so it will be easy to identify. Set the bolt aside someplace safe until you install the new alternator. Release the safety clip connecting the wiring harness. The only other wiring heading into the alternator is the control harness.
Do you need to remove serpentine belt to change alternator?
As you loosen the bolts, the alternator will slide in the bracket under the tension of the belt. You may not need to remove the serpentine or accessory belt if it’s not damaged.
How to replace an alternator on a 1995 GMC?
Somewhere on your vehicle there is a tensioner pulley. You’ll need to move it enough to slip the belt off the pulley. Our ’95 GMC has a standard spring-loaded GM tensioner that required us to pull it back with a wrench.
What kind of wrench do you need to replace an alternator?
Unscrew the bolt holding it in place and pull it from where it’s connected. The bolts will likely require standard sized sockets or wrenches in American made vehicles, and metric in most foreign applications. The only other cable running to the alternator connects to a harness, so it will be easy to identify.
How do you install a new alternator in a car?
Installing the New Alternator Slide the new alternator into place. You might have to wiggle the alternator around to squeeze it back into place in a crowded engine bay. Insert the mounting bolts. Slide the mounting bolts through the alternator and into the mounting bracket. Run the belt over the new alternator pulley.
How do you tighten the belt on an alternator?
Tighten the alternator bolts. With the serpentine or alternator belt safely seated on the alternator pulley, use the same wrench you used to loosen to the bolts to tighten them again. As you tighten the bolts, the alternator will stop tipping forward, which will increase the tension on the belt.
How many bolts do you need to replace an alternator?
Our model required the removal of three bolts: one at the front and two at the rear. With the old alternator in your hand you’re half way home. You’ll likely find getting the new one back in goes much faster since you already know what size the bolt heads are and where everything is.
Where does the serpentine belt go on an alternator?
If you do not have a diagram on the vehicle or in your service manual laying out the direction your serpentine belt travels through the pulleys, take a picture of it with your phone to refer to when installing the new belt. A strictly alternator belt will likely only go around an alternator pulley and the crank pulley at the bottom of the engine.
