Why is there no Comm on my scan tool?
Why is there no Comm on my scan tool?
Could the magnetic interference of all the wires being bundled together cause the lack of communication to the scan tool?? I know that there are 2 pins on the DLC that can be tested for resistance to see how far the lack of comm goes. can anyone tell me what pins and how much resistance there should be?
Can you do crank relearn without a scanner?
You can do the crank relearn without a techII scanner… I’ve seen it done and thought about doing it myself. It is much simpler then the process you describe and it is no different then when you do it WITH the scanner….. Doing it with the scanner guarantees you A) do it right and B) have it done. how was it done?
Why does my Phoenix scan tool not work?
It might be the scan tool we had problem with the cables. Yeah Phoenix has all the nicer stuff including a wireless scan tool can’t remember the brand though. I’ve been working with different shops waiting on a call from a trucking company.
Why is the OBD II scanner not communicating?
Check the fuse box (Power Panel), it might be the reason why PCM isn’t able to receive power as well as communicate.
You can do the crank relearn without a techII scanner… I’ve seen it done and thought about doing it myself. It is much simpler then the process you describe and it is no different then when you do it WITH the scanner….. Doing it with the scanner guarantees you A) do it right and B) have it done. how was it done?
Could the magnetic interference of all the wires being bundled together cause the lack of communication to the scan tool?? I know that there are 2 pins on the DLC that can be tested for resistance to see how far the lack of comm goes. can anyone tell me what pins and how much resistance there should be?
What do the numbers mean on a MODIS scope?
These numbers indicate divisions of time (left to right) and divisions of voltage (bottom to top). As a rule most scopes are divided 10 divisions of time and 8 divisions of voltage. This is where the MODIS is different… you will notice that there are 10 division of voltage.
How to set the trigger on MODIS MODIS-aeswave?
Make sure you set trigger source on the channel you are using. Set the trigger level at 100 mV. Set the trigger position one division over from the left. Set to trigger on the rising slope. Scope Hook-up: Clamp the amp probe around the positiv module. If the pattern is upside down reverse the probe & re-clamp.
