Why is my liftgate not lifting the load?

Platform will lift rated loads, but drifts down. Platform will not lower. Platform lowers extremely slowly. Bent latch pin. Hydraulic oil leaks from cylinder rod end. Platform will not raise to full raised position. Broken roller wheel.

What can I do about a broken liftgate?

Bent latch pin. Hydraulic oil leaks from cylinder rod end. Platform will not raise to full raised position. Broken roller wheel. Standard Series and Deluxe Series (AST and ATU) – This is a link to the Standard Series and Deluxe Series liftgate repair manual.

Is it normal for an Anthony liftgate to break?

Anthony Liftgates don’t break often, but even the most rugged parts don’t last forever. Damage or normal wear and tear can interfere with normal liftgate operation. We’ve prepared this section to help guide you step-by-step through the most common troubleshooting procedures for liftgate repair.

What causes lift runner to hang up on one side?

Platform lowers in a jerky fashion. Platform runner hangs up on one side when lowering. Broken lift chain. Broken platform assist spring. Platform lowers slower than normal. Platform closes and/or opens too slow. Platform will not close completely. Platform will not close at all, motor does run.

What should I do if my rear lift gate is not working?

Pull down the rear gate until it starts to close automatically. The system will be initialized once the gate is fully closed. Check that the power rear gate operates correctly. If the above fails then I would try disconnecting the battery.

What to do if one of the coils on the liftgate is bad?

Coil has power. If in your test the platform closes fine but will not open (or the opposite) either the one coil is bad or the valve. If coil is getting power you can reverse the two coils and try the function again. If the one coil is bad the opposite will happen. If the opposite does not happen replace the coils and valve.

Where can I find the liftgate repair manual?

Standard Series and Deluxe Series (AST and ATU) – This is a link to the Standard Series and Deluxe Series liftgate repair manual. This is a PDF file and you need to download Adobe Acrobat Reader if you do not already have this on your system. Platform will not raise, liftgate motor does run. Platform will not raise, motor does NOT run.

Is there a problem with my Dodge Caravan?

Conditions only noticed twice in 8000 miles since. Have had problem with shifting on 2014 caravan. When going up hill at low speeds transmission shifts to higher gear , after pressing gas peddle quite far it will downshift. Letting off gas. It will up shift. Very hard to maintain constant speed. Also from time to time.

Why does my Dodge Grand feel like it is stalling?

The car shudders and feels like it is trying to stall on the last downshift while slowing to a stop. Occasional upshifts are very harsh. Sometimes the transmission lugs like a manual transmission in too high of a gear. Dealer tried reprogramming the powertrain, and this helped but did not solve the problem.

What to do if your Dodge Caravan liftgate is not working?

If you own a 2005 Dodge Caravan/Voyager/Town and County and have power liftgate problems where the rear power door is not operating, here are some diagnostic tips: The body control module (BCM) sends 5 volts out to the lift gate switch. When you flip the switch to open the liftgate, the switch grounds the circuit and the voltage falls to 0.

How to replace rear liftgate struts on Dodge Caravan?

Dave from Ghetto Van Adventures shows you how to replace the rear hatch support shocks struts for a 2001-2007 dodge caravan. This is easy to do using the dodge caravan liftgate strut replacement set from amazon. If you like our video’s please subscribe and give us a thumbs up and leave your comments below. Loading…

Is there a failure of the lift gate control module?

I have experienced what appears to be a failure of the Lift Gate Control module. I have a 2002 TrailBlazer LS, standard wheelbase. I have checked with a multimeter and confirmed a good ground and 12 v through the wires to the lift gate and there is no evidence of broken wires.

Can a lift gate be changed by center lock?

However, the fuse blew again in less than a day. Was this answer helpful? You can change the machine of lift gate by normal center lock, like this : It’s comes with small rule you’ll fix it by any hall on the body it’s and connect the two wire with the original harness.

How to repair a broken liftgate roller wheel?

Broken roller wheel. Standard Series and Deluxe Series (AST and ATU) – This is a link to the Standard Series and Deluxe Series liftgate repair manual. This is a PDF file and you need to download Adobe Acrobat Reader if you do not already have this on your system. Platform will not raise, liftgate motor does run.

Why is my liftgate not lifting the load?