Why is my Blazer engine cranking but not starting?

Symptoms of a bad rotor can be a “slight miss or a mild rough idle” and if not replaced it will eventually lead to a condition where as the “Engine cranks but won’t start” 1994 blazer, 4.3 liter .

Why does my 94 S10 Blazer not start?

Looking at the contacts in the fuse box for the fuse, the contacts on one side are shiney, while on the other side sort of a dark dull brass look, obvious color difference. So I installed a new fuse. I then tryed to start the car, and it started right up.

Why does my GM 4.3L engine not start?

No Start Condition Basics There are three very basic components that the engine, in your GM vehicle, needs to start and they are: Air, Fuel and Spark. When your 4.3L, 5.0L or 5.7L GM vehicle cranks but does not start, it’s because one of these components is missing from the mix.

How can I tell if my blazer has a spark or not?

I pulled the fuse, it looked like it was the factory original. Looking at the contacts in the fuse box for the fuse, the contacts on one side are shiney, while on the other side sort of a dark dull brass look, obvious color difference. So I installed a new fuse.

What kind of engine does a Chevy Blazer have?

1996 Chevy Blazer. 6 cylinder engine. While driving on the highway my Chevrolet Blazers engine just shut off. I pull over, wait a minute, then start the engine and continue down the highway again. A minute later the engine shuts off again. This happens 7 or 8 times.

Why does my fuel pump not start after sitting?

When the key is turned on the fuel pump only gets 2 seconds of power, so if the line pressure is at zero there isn’t enough run time to pressurize the fuel system. Cycling the key a few times forces the pump to run for 6 seconds instead of just 2 and this will pressurize the system and allow for a quick start

Why does my 1999 Chevy Blazer not start?

I have a,1999 blazer I put a new battery in. And now it the three or four times to start after I get it started in don’t have a problem starting it all day New fuel pump, pressure is good. New programed ecm, new delco spider. , still injectors are not emitting fuel. Starter fluid will fire the engine but won’t stay running.

What can the issue be with a 1994 Chevy S10 Blazer?

I have problems with my 1994 Chevy s10 blazer. when I put the key in and turn it will NOT start right up. it will crank but not start. what can the issue be 154 people found this helpful. when it doesn’t start, you need to test fuel injectors for 12 volts and a pulse 31 people found this helpful. What about the ECM module.

Can a 93 K5 Blazer 5.7 start when cold?

My 93 k5 blazer 5.7 will start and run fine when the engine is cold. After it warms up it dies. Try to start it again and it sounds like it tries to start then the starter will bog and sometimes it turns over fine but just won’t start until it cools down.

What causes a Chevy Blazer to shut off while driving?

Sudendly looses power and shuts off while driving… Coolant or antifreeze Oil Fuel pump Fuel filter Battery Fuses For two week’s prior to incident when i shut off the truck i could hear a boiling like sound coming from the coolant resivoir.

Why is my Chevrolet S10 cranks no start?

You could also test your compression if it is low in all cylinders then you could have a bad timing chain. This will cause exactly your problem. Lots of fuel, lots of spark, but nothing firing at the right time. Hope that’s not it! 6 people found this helpful.

Why does my S10 Blazer have no spark?

I found that I had “no spark” and that I had 60 psi of fuel pressure present and holding. So that isolated my problem down to the electrical ignition system. My Distributor was replace about a 2 years ago. The Distributor Cap, Rotor, Spark Plug Wires, and Spark Plugs were replaced about 3 months ago.

Is the spark good and blue on a 98 S10?

You should get something with starting fluid. Although, if you do that again, use Carb cleaner. It won’t wash away lubricants like starting fluid. Is the spark good and blue?

Why does my car not start when I crank the engine?

The crankshaft position (CKP) sensor monitors the position or rotational speed of the crankshaft. If the crankshaft position sensor has failed completely, and isn’t sending a signal to the (ECU) at all, then the computer won’t send any fuel to the injectors. This will leave you unable to start the car.

How to know if your engine has no spark?

First Confirm Your Engine Has No Spark. 1 Disable the fuel system by removing the fuel pump fuse or relay. 2 Insert a spark plug tester into the plug boot and ground it on a piece of metal on the engine. 3 Finally, Have someone crank the engine and watch for spark.

What causes a car to stall with no spark?

Consequently, An old or failing ignition pickup may cut out signal intermittently, which may cause the engine to stall. The engine may suddenly just shut off, almost as if the key had been turned off. Depending on the nature of the issue, sometimes the vehicle can be restarted and driven.

How to diagnose a p1351 Chevrolet ignition circuit?

Start by checking the “Possible Causes” listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector’s pins. The cost to diagnose the P1351 CHEVROLET code is 1.0 hour of labor.

How to troubleshoot ignition system on Chevy Blazer?

Remove the coil wire from the coil, and hold the 12-volt test light close to, but not touching, the secondary coil tower that the coil wire was plugged into. Turn the ignition to the “Start” position and watch the coil. A bright spark should jump from the coil tower to the test light.

What to do if spark doesn’t work on S-10 Blazer?

If the spark is weak or doesn’t happen, replace the coil. Remove the plug wire from a spark plug, leaving it attached to the distributor cap (or coil pack on S-10s with distributor-less ignition systems) and turn the ignition key to the “Start” position. A bright spark should cross an inch or more to the engine block.

Why does my 93 K5 Blazer not start?

What to do if your Chevy Blazer won’t start?

Unplug wire from coil to disturber and crank engine see spark at coil what is wrong please help When you try to start running the engine or press start, the vehicle won’t turn on. The engine simply turns but it does not work as it should. Check the ignition module, located in the distrbutor and check as well the sparking.

When to check your distributor rotor and cap?

Engine misfires can occur for a number of reasons. Checking your distributor rotor and cap to see if they need to be replaced is one way to ensure that everything is in solid working order. 2. Car doesn’t start

What causes a car to not start when the distributor is not on?

Car doesn’t start When the distributor cap isn’t on tightly or is malfunctioning, the engine is unable to send the spark through the entire circuit required to move the cylinders – which ultimately make the car run. 3. Check Engine Light comes on