Why does my Mercedes Benz hesitate to accelerate?
Why does my Mercedes Benz hesitate to accelerate?
-Air filter and throttle body are clean. -I haven’t changed the MAF in the 2 years that I’ve owned the car, and i tried running the car with the MAF unplugged; the problem was the same except now the idle was constantly low and rough. The problem is slowly getting worse. I’m contemplating ordering a new MAF or maybe a set of new coils..
Why does my Duramax throttle response take so long?
He said that the throttles are sensor controlled and when you push on the gas the sensor can interpret that you want to go faster/slower than you want and it takes it a split second to figure out the correct reading and that can cause the hesitation. He said there was no adjustment and said i had to change the way i drive or deal with it.
Why does my car hesitate when I take off?
1) a hesitation or stutter when accelerating from a full stop. the harder I accelerate the more it hesitates. but only on take off, as if it cant handle the sudden surge of gas. If i baby the pedal (and i mean really ease on it) from a full stop nothing happens.
Is there turbo lag on a 2006 Duramax?
The older generations of the Duramax had varying degrees of “turbo lag” which is why I didn’t buy one. Most of the 2006s have the LBZ engine and every LBZ I’ve driven had no lag at all…the instant response was right there!!! I would have to think that there is some sort of problem with the truck.
He said that the throttles are sensor controlled and when you push on the gas the sensor can interpret that you want to go faster/slower than you want and it takes it a split second to figure out the correct reading and that can cause the hesitation. He said there was no adjustment and said i had to change the way i drive or deal with it.
What happens when a Duramax engine goes down?
Not only does this mean game-over for the engine, but it results in a truck that’s down for weeks (if not months) and a huge chunk of change missing from your wallet. The failure is most common in higher horsepower engines, but can still occur in moderately modified and even stock power plants.
What causes the injector on a Duramax to fail?
The two primary failure points of the factory injectors are internal cracking of the injector body itself and corrosion-induced failure of the internal ball seat. The solenoid style Bosch units found in the LB7 employed a non-hardened internal ball seat to seal the injector.
The older generations of the Duramax had varying degrees of “turbo lag” which is why I didn’t buy one. Most of the 2006s have the LBZ engine and every LBZ I’ve driven had no lag at all…the instant response was right there!!! I would have to think that there is some sort of problem with the truck.
