Other

Why does my Chevy c1500 not start up?

Why does my Chevy c1500 not start up?

SOURCE: No fuel to the injectors on a 1997 Chevy c1500. can be the distributor or maybe the fuel pump let the truck sit and then turn key almost on but not enough to initiate start up and see if you hear pump in the gas tank and if thats not it, it could very well be your distributor it might be moist in the cap or button area

What causes hesitation and stumbling in a 1990 Chevy c1500?

An expert that got 10 achievements. Re: 1990 chevy c1500 hesitation and stumbling during… Based on what you said, I would say the engine is starving for fuel. The computer has to be disabled to set timing – there should be a procedure for that. I would start with checking fuel pressure at the throttle body.

Where are the fuses on a 1993 GM 4.3L?

In the table below you’ll find the fuse location and description of the fuses of the fuse box on 1993 4.3L, 5.0L, 5.7L TBI equipped 4.3L, 5.0L, and 5.7L pickups. IMPORTANT: The fuse box illustration and fuse descriptions cover the vehicles in the ‘Applies To:’ box on the right column.

What is the TPS code for a 1990 Chevy c1500?

TPS code 22 low voltage 3. MAP code 34 low voltage. 4. IAC valve stuck. 5. timing is off. problems fixed so far. 1.

In the table below you’ll find the fuse location and description of the fuses of the fuse box on 1993 4.3L, 5.0L, 5.7L TBI equipped 4.3L, 5.0L, and 5.7L pickups. IMPORTANT: The fuse box illustration and fuse descriptions cover the vehicles in the ‘Applies To:’ box on the right column.

Why is my Chevy Vortec 4300 V6 leaking fuel?

In the L35 and LF6 engines, the spider injectors are known to leak at the pressure regulator and at the supply and return lines due to a design fault. Outside of leaking fuel onto the exterior of the engine itself, it can cause excess fuel to get sucked into the engine.

Are there any problems with the Chevy 4.3 Vortec engine?

The 4.3 Vortec engines made from 1996-2002 (L35 and LF6) have been reported to have engine knock problems. In a properly functioning engine, fuel burns in even pockets instead of all at once. The pockets burn in even timing, in sync with engine cycles. Engine knock occurs when the fuel burns unevenly and out of sync with the engine cycles.

Is the Chevy Vortec 4300 a reliable engine?

Chevy Vortec 4300 (4.3L V6) Engine Reliability Overall, the 4.3 vortec is a very strong and reliable motor, proven by it being the longest lasting production vortec engine. Generally, these engines are extremely capable of lasting up to 300,000 miles.

What causes engine knock on a 4.3L Vortec?

Engine knock can be caused by a ton of factors, such as low-grade fuel, bad spark plugs, carbon build-up, etc. Engine knock is terrible for your engines internals and can cause serious damage to the pistons and to the cylinder walls. On the 4.3L vortec, the cause of the engine knock has not necessarily been figured out, still to this day.

How to troubleshoot a Chevy 4.3 engine?

1 Common Problems. A common complaint with the Chevy 4.3 engine is that it doesn’t idle well, it’s loud and makes awkward noises. 2 Idle Air Control Valve and Throttle Conrtol Switch. Open up the hood and look at all the wires, spark plugs, tubes, vacuum lines and valves. 3 Check Your Oil. 4 Vehicle Fuilds. …

SOURCE: No fuel to the injectors on a 1997 Chevy c1500. can be the distributor or maybe the fuel pump let the truck sit and then turn key almost on but not enough to initiate start up and see if you hear pump in the gas tank and if thats not it, it could very well be your distributor it might be moist in the cap or button area

An expert that got 10 achievements. Re: 1990 chevy c1500 hesitation and stumbling during… Based on what you said, I would say the engine is starving for fuel. The computer has to be disabled to set timing – there should be a procedure for that. I would start with checking fuel pressure at the throttle body.

1 Common Problems. A common complaint with the Chevy 4.3 engine is that it doesn’t idle well, it’s loud and makes awkward noises. 2 Idle Air Control Valve and Throttle Conrtol Switch. Open up the hood and look at all the wires, spark plugs, tubes, vacuum lines and valves. 3 Check Your Oil. 4 Vehicle Fuilds.

What are the symptoms of a Chevy Vortec engine problem?

Symptoms of Failing Idle Control Valve and Throttle Position Sensor 1 Rough idling 2 Engine stalling 3 Hesitation during acceleration 4 Hard shifting and lack of power 5 Lack of accelerator responsiveness 6 P0122 engine code (TPS sensor)

What makes a Chevy 5.7 TBI run cold?

The regulator is spring loaded and if the pressure isnt enough the fuel doesnt even get to the return line.. Its a hell of a lot easier than checking it with a gauge. There is a temperature sensor that tells the computer how to mix fuel/air since the truck does not have a choke. I have had to replace this sensor on a few of my past trucks.

Why does my Chevy truck not start when it gets cold?

Seems to be fuel pressure but can’t smell any gas like it was flooding. It does’nt even fire like it wants to start. It has been starting hard and I would have to turn key on and off 4 or 5 times before I could get it to start but once it started it would run just fine. has any chevy owners out there delt with this before??

Are there any problems with the Chevy Silverado?

If this sensor or switch fails, the vehicle will display the service 4WD message. This faulty 4WD issue is among the most common problems with the 2008 Chevy Silverado, according to reports from owners.

What are the most common GMC truck problems?

One of the most common 2007-2013 GMC and Chevy truck problems owners experience is excessive oil consumption. This problem led vehicle buyers to launch a class-action lawsuit against GM, which alleged 2010-2013 vehicles with Generation IV 5.3 Liter V8 Vortec 5300 engines were defective.

Can a faulty fuel pump cause bad acceleration?

A faulty fuel pump will not pose problems at low speeds, but you might be left wanting when you are looking for quick acceleration. Fuel pumps usually have a long life, so checking the fuel pump on your car shouldn’t be your first action.

What should I do if my car hesitates when I press the gas?

Here’s what you might discover—and what you can do to fix the problem: Dirty air filter. The Fix: Replace the air filter. The spark plugs may be dirty or worn. The Fix: Replace spark plugs. The ignition wires may be bad. The Fix: Inspect and replace ignition wires. Ignition system problems. The Fix: Check distributor cap or rotor.

What causes a Chevy C / K 1500 to bog down?

My truck bogs down (and tries to die) when I give it gas to accelerate off of a stop. There is often a backfire or two when this happens. Pumping the gas does not help. I basically have to crawl through any intersection until it picks up a bit of speed from idle. The truck idles smoothly, and it runs fine once it’s above about 5-10mph or so.

Why does my Chevy Silverado not accelerate when I push the gas?

If your Chevy Silverado won’t accelerate, that is a serious cause for concern. There are a lot of different reasons that can cause this. Diagnosing the issue can be narrowed down by whether the engine is still revving when you push the gas or not. There is a section for each scenario with likely causes for each.

What are the problems with a 1990 Chevy c1500?

Unresponsive to gas peddle at times and has major dead spots. not sure if its the injectors or the timing or if i need a tps sensor Clicking this will make more experts see the question and we will remind you when it gets answered. problems so far: injectors shot turck was pissing gas the second the lines pressurized. 2. TPS code 22 low voltage 3.

What causes a car engine to run too rich?

The intake temperature sensor is often installed inside of the MAF sensor and can not be replaced separately. A faulty fuel pressure regulator will cause the fuel pressure to get too high or too low. This can cause a mixture that is too rich.

Why does my Chevy k1500 stall when gas is released?

I have been working on our 89 Chevy K1500 and am still having an idle issue. The truck idle drops and lopes and occasionally completely stalls. This usually happens when driving slow in town… backing out of parking space, letting off gas when coming to a stop sign or to park etc. It does fine to start and accelerate.

Is the oil leaking on my 94 k1500?

Only 108k miles on a 94 k1500 no oil leaks but is using oil like it’s going out the pan with no plug I know my way around this truck n I’ve replaced n checked damn near everything pcv vacumme lines gutted cat which was clogged next is compression test n plugs again

What causes a Chevy C / K 1500 to drop in idle?

In order to change these, you have to completely removed the distributor and completely disassemble the distributor to get the pickup off and replace it. These components are very sensitive and when failing, will cause misfire, idle issues, and cause it to burn rich as well. 11 out of 12 issues like this are because of this pickup coil.

What’s the fuel Gage on a 1993 Chevy truck?

Fuel gage never wavered at 12-13 psi. MAP around 2.9v when PW 2.8MS when truck seemed to be falling a little flat under brake torque. This thing is really close to getting a carburetor on it.

Author Image
Ruth Doyle